Sanyo WTC500L owner manual Connecting the AC Power Cord, Projector side AC outlet side

Installation

Connecting the AC Power Cord

This projector uses nominal input voltages of 100–120 V or 200–240 V AC and it automatically selects the correct input voltage. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of electrical shock, do not plug into any other type of power system.

If you are not sure of the type of power being supplied, consult your authorized dealer or service station.

Connect the projector with all peripheral equipment before turning the projector on.

CAUTION

The AC outlet must be near this equipment and must be easily accessible.

Connect the AC power cord (supplied) to the projector.

✔Note:

•Unplug the AC power cord when the projector is not in use. When the projector is connected to an outlet with the AC power cord, it is in stand-by mode and consumes a little electric power.

NOTE ON THE POWER CORD

AC power cord must meet the requirements of the country where you use the projector. Confirm the AC plug type with the chart below and proper AC power cord must be used. If the supplied AC power cord does not match your AC outlet, contact your sales dealer.

Projector side			AC outlet side
	For the U..S..A.. and Canada		For Continental Europe	For the U..K..
		Ground

To power cord
connector on your	To the AC outlet..
		To the AC outlet..	To the AC outlet..
projector.	(120 V AC)	(200–240 V AC)	(200–240 V AC)

23