Sanyo PLC-XU355A, PLC-XU305A owner manual Appendix Indicators and Projector Condition

Appendix

Indicators and Projector Condition

Check the indicators for projector condition.

Indicators			Projector Condition
	WARNING	LAMP
POWER		REPLACE
red/green	red	yellow
			The projector is off. (The AC power cord is unplugged.)
			The projector is in stand-by mode. Press the ON/STAND-BY button
			to turn on the projector.
			The projector is operating normally.
			The projector is preparing for stand-by or the projection lamp is
			being cooled down. The projector cannot be turned on until cooling
			is completed and the POWER indicator stops blinking.
			The projector is in the Power management mode.
			The temperature inside the projector is abnormally high. The
			projector cannot be turned on. When the projector is cooled down
			enough and the temperature returns to normal, the POWER
			indicator stops blinking and the projector can be turned on. (The
			WARNING indicator keeps blinking.)

The projector has been cooled down enough and the temperature

returns to normal. When turning on the projector, the WARNING indicator stops blinking. Check and clean the filters.

The projector detects an abnormal condition and cannot be turned on. Unplug the AC power cord and plug it again to turn on the projector. If the projector is turned off again, unplug the AC power

cord and contact the dealer or the service center for service and checkup. Do not leave the projector on. It may cause an electric shock or a fire hazard.

• • • green	• • • red	• • • off
• • • blinks green	• • • blinks red

When the projection lamp reaches its end of life, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow, replace the projection lamp with a new one promptly.

72