Sanyo PLC-XTC50AL owner manual Capture, Logo PIN code lock

Setting

Capture Capture

This function enables you to capture an image being projected to use it for a starting-up display or interval of presentations.

Select Capture and press the SELECT button.

A confirmation box appears and select [Yes] to capture the projected image.

After capturing the projected image, go to the Logo select function and set it to “User”.Then the captured image will be displayed the next time you turn on the projector.

To cancel the Capture function, select [No].

✔Notes:

•Before capturing an image, select “Standard” in the Image Menu to capture a proper image (p.41).

•A signal from a computer can be captured up to XGA (1024 x 768). A signal from video equipment can be captured except for 720p, 1035i, and 1080i.

•When capturing the image that has been adjusted by the Keystone function, the adjusted data is automatically reset and the projector captures an image without keystone correction.

•When the Logo PIN code lock function is set to “On,” the Capture function cannot be selected.

•When starting to capture a new image, the previously stored image is cleared even if you cancel the capturing.

•“User” cannot be selected when the image is not captured.

Select [Yes] to capture the projected image.

Select [Yes] to stop capturing.

Logo PIN code lock	Logo PIN code lock
This function prevents an unauthorized person from
changing the screen logo.
Off ........... The screen logo can be changed freely from
the Logo Menu (p.51).
On............ The screen logo cannot be changed without
a Logo PIN code.
If you want to change the Logo PIN code lock setting,
press the SELECT button and the Logo PIN code dialog
box appears. Enter a Logo PIN code by following the
steps below. The initial Logo PIN code is set to “4321” at
the factory.

50