Sanyo PLC-XK2600 Remote Control Battery Installation, Remote Control Operating Range, Menu button

Part Names and Functions

Remote Control Battery Installation

1	Open the battery	2	Install new batteries	3	Replace the
	compartment lid.		into the compartment.		compartment lid.
			Two AAA size batteries
			For correct polarity (+
			and –), be sure battery
			terminals are in contact
			with pins in compartment.

To ensure safe operation, please observe the following precautions : ● Use two (2) AAA or LR03 type alkaline batteries.

●Always replace batteries in sets.

●Do not use a new battery with a used battery.

●Avoid contact with water or liquid.

●Do not expose the remote control to moisture or heat.

●Do not drop the remote control.

●If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

●Risk of an explosion if battery is replaced by an incorrect type.

●Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Remote Control Operating Range

Point the remote control toward the projector (Infrared Remote Receiver) when pressing the buttons. Maximum operating range for the remote control is about 16.4'(5 m) and 60 degrees in front of the projector.

16.4' (5 m)

30°

30° Remote control

Remote Control Code

The 2 different remote control codes (Code 1–Code
2) are assigned to this projector. Switching the remote
control codes prevents interference from other remote
controls when several projectors or video equipment next
to each other are operated at the same time. Change the
remote control code for the projector first before changing
that for the remote control. See "Remote control" in the	MENU button
Setting Menu on page 52.
Press and hold the MENU and IMAGE buttons for more
than five seconds to switch between the Code 1 and	IMAGE button
Code 2. The initial code is set to Code 1.

12