Sanyo PLC-XK2600 owner manual Terminal, Direct on, Shut down

Setting

Terminal

The COMPUTER IN 2/MONITOR OUT terminal on the back of the projector is switchable for computer input or monitor output. (See page 9) Select Computer 2 or Monitor Out with the Point ▲▼ buttons.

Computer 2 . . computer input

Monitor Out . monitor out

Terminal function is not available when selecting Computer 2 to the input source. Change the input source to the others (Computer 1, and so on) so that the Terminal function will be available. (pp.25, 36, 37)

Power management

For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.

Select one of the following options:

Ready	When the lamp has been fully
	cooled down, the POWER
	indicator changes to green
	blinking. In this condition, the
	projection lamp will be turned on
	if the input signal is reconnected
	or any button on the top control or
Shut down	remote control is pressed.
	When the lamp has been fully
	cooled down, the power will be
Off	turned off.
	Power management function is
Timer	off.
	If the input signal is interrupted
	and no button is pressed for more
	than 30 seconds, the timer display
	with No signal appears. It starts
	the countdown until the lamp is
	turned off. Use the Point ▲▼
	buttons to set the Timer (1~30
	min).

Note:

• Factory default is Ready: 5 min.

Direct on

When this function is set to On, the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.

Note:

•Be sure to turn off the projector properly (see “Turning Off the Projector” on page 20). If the projector is turned off in the incorrect sequence, the Direct on function will not work properly.

Power management

Time left before Lamp is off.

49