Sanyo PLC-WXE45 owner manual Pointer to Computer 1 and then press the Select

Video Input

Input Source Selection (Component, RGB Scart 21-pin)

Direct Operation Remote Control

Select Computer 1 by pressing the COMPUTER button on the remote control.

Before using COMPUTER button, select the correct input source through Menu operation as described below.

COMPUTER button

COMPUTER button

Computer 1

Computer 2

*

Menu Operation

1	Use the MENU button to display the On-Screen Menu.
	Press the Point ◄► buttons to move the red frame
	pointer to the Input Menu icon.
2	Use the Point ▲▼ buttons to move the red arrow
	pointer to Computer 1 and then press the SELECT
	button.
3	After the Source Select Menu appeared for Computer
	1, move the pointer to Component or RGB (Scart) and

then press the SELECT button.

Component When the input source is coming from video equipment connected to the COMPUTER IN 1/COMPONENT IN terminal with a Component-VGA Cable (not supplied), select Component.

RGB (Scart) When the input source is coming from video equipment connected to the COMPUTER IN 1/COMPONENT IN terminal with a Scart-VGA Cable (not supplied), select RGB (Scart).

Note:

•Computer 2 is not displayed when the COMPUTER IN 2/ MONITOR OUT terminal is set as Monitor out (p.44). •Computer 2 (COMPUTER IN 2/MONITOR OUT) can accept only RGB signal.

•When the Input Search function is set On1 or On2, the input signal will be searched automatically (p.44)

*See Note at the bottom of this page.

Input Menu		Input Menu icon
		Move the pointer (red arrow)
		to Computer 1 and press the
		SELECT button.
	Computer
1
		Source Select Menu
		Move the pointer to Component
		or RGB (Scart) and press the
		SELECT button.

35