Sanyo PLC-WXE45 owner manual Part Names and Functions Rear Terminal, ③ LAN Connection Terminal

Part Names and Functions

Rear Terminal

① ② ③ ④ ⑤ ⑥ ⑦

COMPUTER IN 2 /

MONITOR OUT

VIDEO IN

S-VIDEO IN

(VARIABLE)

RAUDIO OUT

LCOMPUTER / (MONO) COMPONENT

AUDIO IN

⑨ ⑧

①COMPUTER IN 1/COMPONENT IN

Connect output signal from a computer, RGB scart 21-pin video output, or component video output to this terminal (pp.14, 16).

When the cable is of the longer variety, it is advisable to use this terminal and not COMPUTER IN 2/MONITOR OUT.

②SERVICE PORT

When controlling the projector from a computer, connect the computer to this connector with a control cable.

③LAN Connection Terminal

Connect the LAN cable (Refer to the owner's manual of "Network Set-up and Operation".).

④COMPUTER IN 2/MONITOR OUT

This terminal is switchable and can be used for input from a computer or output to the other monitor.

Set the terminal up as either Computer input or Monitor output properly. [Used for Monitor out, this terminal outputs only incoming signal from COMPUTER IN 1/COMPONENT IN terminal (pp. 14, 44)].

⑤S-VIDEO IN

Connect the S-VIDEO output from video equipment to this jack (p.15).

⑥AUDIO IN

Connect the audio output from video equipment

connected to ⑤ or ⑨ to this jack. [When the audio output is monaural, connect it to L (MONO) jack (p.15).

⑦AUDIO OUT (VARIABLE)

Connect an external audio amplifier to this jack (pp.14 - 16).

This terminal outputs sound from AUDIO IN terminal (⑥ or ⑧).

⑧COMPUTER/COMPONENT AUDIO IN

Connect the audio output (stereo) from a computer

or video equipment connected to ① or ④ to this jack (pp.14, 16).

⑨VIDEO IN

Connect the composite video output from video equipment to VIDEO jack (p.15).