Hitachi CMP5500, 55PMA550E, 37PD5000, 55PD5000 user manual Safety Instructions

Page 8

SAFETY INSTRUCTIONS(continued)

CAUTION

Be careful in moving the monitor.

Neglect could result in an injury or damage.

Do not move the monitor during use. Before moving, disconnect the power plug and all external connections.

You are advised to move the monitor with two persons.

Avoid any impact or shock to the monitor; particularly take care of glass screen.

Do not put anything on top of the monitor.

Placing anything on the monitor could result in loss of balance or falling, and cause an injury or damage. Use special caution in households where children are present.

Avoid a humid or dusty place.

Placing the monitor in a smoke, a highly humid, dusty place, oily soot or corrosive gas could result in fire or electrical shock.

• Do not place near the kitchen, a humidifier or other place where there is oil, smoke or humidity.

Avoid a high temperature environment.

The heat could have adverse influence on the monitor and other parts, and could result in transformation, melting or fire.

Do not place the monitor, the remote control and other parts in direct sunlight or near a hot object such as heater, etc.

Do not put the monitor in a place where the temperature is widely changing.

Doing so could cause the unit to tip over or become damaged, causing injury.

Be especially careful in households with small children.

• Although the product has a hook to prevent tipping, leaning items against it could tip the unit over, causing injury.

Remove the power cord for complete separation.

For safety purposes, disconnect the power cord if the monitor is not to be used for prolonged periods of time.

Before cleaning, turn off and unplug the monitor. Neglect could result in fire or electrical shock.

PRECAUTIONS

• Installation environment

Disconnect the

plug from the power outlet.

Do not obstruct a ventilation hole.

Do not put the monitor on carpet or blanket, or near a curtain which has a possibility of obstructing a ventilation hole of the monitor.

Do not put the monitor in the following places.

Hot places such as near heater, place exposed to the direct rays of the sun.

A place where the temperature is widely changing.

Places with soot, dust or high humidity.

Poor air ventilation place.

Place near fire.

A wet place such as bathroom, or shower room.

Place where you can trip over it.

Always vibrating or strongly vibrating places.

Distorted or unstable places.

How to view the monitor

If you use the monitor in too dark a room, your eyes may become tired.

Please use it in a reasonably bright room.

Avoid direct rays of the sun to the screen in order to prevent eye fatigue.

Your eyes will get fatigued after viewing the monitor for long period of time.

Relax your eyes by viewing away from the monitor from time to time.

Please watch the monitor in downward direction.

• Note on image retention

The plasma monitor illuminates phosphor to display images. The phosphor has a finite illumination life. After extended periods of illumination, the brightness of the phosphor will be degraded to such extent that stationary images would burn-in that part of the screen as grayed-out images. Tips to prevent such image retention are:

-Do not display images having sharp brightness differences or high-contrast images, such as monochrome characters and graphic patterns, for long.

-Do not leave stationary images appearing for long, but try to refresh them at appropriate intervals of time, or try to move them using screen saver function.

-Turn down the contrast and brightness controls.

How to clean the plasma screen panel of the monitor

Before cleaning the monitor, turn off the monitor and disconnect the power plug from the power outlet.

To prevent scratching or damaging the plasma screen face, do not knock or rub the surface with sharp or hard objects. Clean the screen with a soft cloth moistened with warm water and dry with a soft cloth. If it is not enough, then use a cloth with mild detergent. Do not use harsh or abrasive cleaners.

• How to clean the cabinet of the monitor

Use a soft cloth to clean the cabinet and control panel of the monitor. When excessively soiled dilute a neutral detergent in water, wet and wring out the soft cloth and afterward wipe with a dry soft cloth.

Never use acid/alkaline detergent, alcoholic detergent, abrasive cleaner, powder soap, OA cleaner, car wax, glass cleaner, etc. especially because they would cause discoloration, scratches or cracks.

6

Image 8
Contents 37PD5200 55PMA500 Remarque English Features Contents Safety Instructions About the SymbolsBe cautious of the power cord connection Be sure to keep safety ground connectionBe careful in handling the battery of the remote control To Earth Fuse Blue to Neutral Cord ClampSafety Instructions Precautions for the cable connection Precaution during transportationDo not physically impact the remote control Set the sound volume at a suitable levelComponent Names Main UnitLoading Batteries Remote controlHandling the Remote Control Installation Instructions InstallationAnti-tumble measures Securing to a wall or pillarConnecting to a PC Monitor rear panelPage Turning Power On and Off Operating InstructionsOperating Instructions Volume Adjustment Input SwitchingWhen a button is pressed, the volume adjustment Audio MuteSize Switching Input Signal Screen DisplayDisplay area selection diagram RGB input Real mode positionUsing the Menu Screen On-screen display system Automatic Adjustment of Screen Position and the ClockOperating Instructions Independent Operation of Multiple Monitors ID NoPicture Menu Timer Menu Off Timer Min 30Min 60Min 120Min 90Min On TimerAudio Menu Off Low Middle High Off OnFunction Menu Movie Setup MenuOff 1280x768 1366x768 Other Features Language MenuAutomatic Store Menu Display Registration conditionOther Features Signal Check Power Save ModeWhen the RGB, RGB2 input is selected Status Display ActionImage Retention of Plasma Display Methods to Reduce the Occurrence of Image RetentionAbout screen defects About residual imagesTroubleshooting Symptoms That Seemingly Appear to be FailuresCheck the way the signal cable is connected Check to see if the input signal matches the monitorEnglish Troubleshooting Actions to Correct Abnormal Displays ExampleProduct Specifications Signal InputRGB terminal D-sub 15-pin connector Pin Input signalProduct Specifications Signal Input Recommended Signal ListWith Digital RGB signal input RGB1 input DVI terminal DVI-DWith Analog RGB signal input RGB2 input Supplement Connecting to a Video Imaging Device An example of connecting video imaging devicesWith DVI-STB and RGB component setup Optional Video Unit FunctionDisplay size selection diagram When you want toInput signal Display screen Remarks AV1 AV2 AV3 RGB2 RGB1 AV4Using a wide-screen monitor PressTime will display 2 pictures Operating Instructions Displaying Multi PicturePictures Split YNR Black Enhancement Auto Colour Film Mode PAL Comb FilterOperating Instructions Picture Menu Colour Management MagentaRed YellowAV2 1st step AV2 2nd step System Colour SystemVideo Input Audio Input Scart OutputRGB2 1st step RGB2 2nd stepVideo input Input connector pin specifications Scart connector pin specificationsWith component input Not UsedProduct Specifications Recommended Signal List With R, G, B Video input AV2 and AV4 inputWith component input AV1, AV2 and RGB2-component input KHz MHzRemote control provided for the optional tuner unit Optional Tuner Unit FunctionFreeze button RGB / Video buttons Time buttonYou may recall the picture mode by Picture mode is changed in followingPress this button to change input Surround On or Off Mode Pressing this button. Each time pressedButtons for Teletext Mode Monitor rear panel Connecting AntennaPrecautions when connecting the antenna TV AV1 AV2 AV3 RGB2 RGB1 AV4 Auto Full Zoom 149Zoom C149LPictures Split 4 pictures 12 pictures Activating the Split mode from the TV screenMulti Picture button Multi Mode button Button Sound mode Off-timerPictures Display will go out in approximately 6 seconds TV positionSplit Strobe Picture FreezingFreeze button During TV mode AbcdeAuto Off Operating Instructions Setup MenuDuring Video signal input Other Functions A2 / Nicam / Sound MultiplexBilingual / Dual sound broadcast Stereo sound broadcastMode button Index button TV / Text button Cancel button Operating Instructions Other FunctionsDVD Player Selection ExampleSnowy picture poor sound Multiple images sound O.KIntermittent interference No picture or soundRF input Input terminals Model Serial Number DEALER/STORE Date Purchased Hitachi Atago Building