NEC NP2000, NP1000 setup guide Setting Wired LAN, Display the Built-in page of LAN Mode

5. Setting the LAN Setting of Projector

■Setting Wired LAN

1Display the “Built-in” page of “LAN Mode”.

Configure the setting of wired LAN in the “Built-in” page of “LAN Mode” selected from On-Screen Menu. If “LAN Mode” is not displayed, refer to “5-1. Displaying On-Screen Menu (LAN Mode)” (page 13).

2Select “Profiles”.

“Profile 1” or “Profile 2” can be stored in the memory of the projector as the setting of LAN.

<1>	Press the SELECT	button once to highlight the “Profiles” field and press the
	button.
<2>	Use the SELECT /	button to highlight “Profile 1” or “Profile 2”, and press the	button.

3Set “DHCP”.

Follow the same procedure as in “5-2. Wireless LAN” ( page 17).

4Input “IP Address”, “Subnet Mask”, and “Gateway”.

Follow the same procedure as in “5-2. Wireless LAN” ( page 17,18).

5Input “DNS Configuration”.

Follow the same procedure as in “5-2. Wireless LAN” ( page 18).

6 Reconnect the network. 5

<1> When all the above items have been input or set, use the SELECT / button to highlight

“Reconnect” and press the button.

7Finalize the setting.

<1> Use the button to highlight [OK] and press the button. The setting will be stored in the memory of the projector.

Setting the LAN Setting of Projector

25