>TCP/IP | > |
On |
|
|
|
>>DHCP Off
>>IP Address 000.000.000.000
>>Subnet Mask 000.000.000.000
>>Gateway
000.000.000.000
>>Bonjour Off
>>Subnet Mask
000.000.000.000
TCP/IP
This section describes how to enable the TCP/IP protocol.
1If TCP/IP is set to Off, use U or V to select On and press [OK].
2Press Z. Each time you press U or V, the selection changes.
3Display the item you want to set and press [OK]. A blinking question mark (?) appears while you are setting DHCP and Bonjour. A blinking cursor (_) appears while you are setting IP Address,
Subnet Mask and Gateway.
4Press U or V to select On or Off as the setting for DHCP and
Bonjour.
For the IP Address, Subnet Mask and Gateway settings, press
U or V to move the blinking cursor to the number you want to change (000 to 255). Use Y and Z to move the cursor right and left.
Note Check with your network administrator for the network address settings.
5Press [OK].
6Press [MENU]. The display returns to Ready.
Printing Operation |