Kyocera FS-3920DN manual Cdrh Regulations, Ozone Concentration

Page 13

Caution Labels

The printer bears any of the following labels.

Laser inside the printer (Laser radiation warning)

For Europe, Asia, and								For U.S.A. and
other countries								Canada

CDRH Regulations

The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration implemented regulations for laser products on August 2, 1976. These regulations apply to laser products manufactured after August 1, 1976. Compliance is mandatory for products marketed in the United States. A label indicating compliance with the CDRH regulations must be attached to laser products marketed in the United States.

Ozone Concentration

These printers generate ozone gas (O3), which may concentrate in the place of installation and cause an unpleasant smell. To minimize the concentration of ozone gas to less than 0.1ppm, we recommend you not to install the printer in a confined area where ventilation is blocked.

xii

Image 13

Contents FS-2020D/FS-3920DN/FS-4020DN Contents 10-1 CompactFlash CF Card10-2 GlossaryLegal and Safety Information Regarding Tradenames Legal InformationLicense Agreements Limited WarrantyIBM Program License Agreement LicenseMonotype Imaging License Agreement Typeface Trademark AcknowledgementGeneral Vii Original SSLeay License Open SSLeay LicensePage Compliance and Conformity Interface ConnectorsLaser Safety Safety InformationLaser Notice Radio Frequency TransmitterOzone Concentration Cdrh RegulationsDeclaration of Conformity Australia Safety Instructions Regarding Disconnection of PowerEN ISO Canadian Department of Communications Compliance StatementDisclaimer Energy Saving FunctionEnergy Star Energy Star Program Symbols Other Precautions Installation PrecautionsEnvironment Other precautions Power Supply/Grounding the MachineHandling of plastic bags Precautions for Use Introduction-xx About the Operation Guide Bracket Bold Conventions in This GuideMachine Parts Components at the Front of the Printer Components at the Rear of the Printer Operation Panel General Guidelines Selecting the Right Paper Paper Type Paper HandlingSpecifications Paper SpecificationsGeneral Guidelines Paper AvailabilityMinimum and Maximum Paper Sizes Condition Selecting the Right PaperComposition Paper SizesPaper Weight Equivalence Table Basis weightMoisture Content Bond Weight lb Europe Metric Weight g/m²Other Paper Properties Paper GrainPaper type to be used Paper type to be selected Special PaperTransparency LabelsPostcards SpecificationThick Paper EnvelopesColored Paper Recycled paper Preprinted PaperPaper Type Paper WeightPaper source Paper Type CassettePaper Handling Loading Paper Loading Paper into the Cassette Page Page Loading Paper Loading Paper into MP Multi-Purpose Tray Page Loading Envelopes into the MP Tray Connecting and Printing Connecting the Network Cable Connecting the USB CableConnecting the Parallel Cable ConnectionsConnecting the Power Cord Changing Network Interface Parameters TCP/IP, TCP/IP IPv6 settingsNetwork Off TCP/IP IPv6 OffSubnet Mask and Gateway TCP/IPSecurity TCP/IP IPv6 On RAStateless Off DHCPv6 Off ?OffTCP/IP IPv6 RAStateless and DHCPv6If you are using NetWare, AppleTalk, IPP, SSL Server or PasswordNetWare AppleTalk On IPP Off SSL Server Off IPSec Off?Auto Security Level High NetWare Frame Type Auto?802.3 ?802.2AppleTalk AppleTalk On ?On IPP OnSSL Server ?Off IPSec On ?OnIPSec Security Level Security Level HighPrinting a Network Interface Status Adjust/ Maintenance Print Network Status Page ?Installing the Printer Driver on Windows PC Installing the Printer DriverExpress Mode Custom Mode Installing the Printer Driver on Mac OS Open System Preferences and click Print & Fax Page Page Status Monitor Accessing the Status MonitorExiting the Status Monitor Screen OverviewStatus Monitor icon Sound Notification Tab Status Monitor SettingsAppearance Tab Uninstalling Software Windows PC Maintenance Frequency of toner container replacement Toner Container ReplacementGeneral Information Starter Toner ContainerReplacing the Toner Container Close the top cover Proceed to the next section Maintenance Replacing the Waste Toner Box Page Cleaning the Printer Prolonged Non-use Prolonged Non-Use and Moving of the PrinterMoving the Printer Troubleshooting Tips Symptom Check Items Corrective ActionsPrinted Results Corrective Action Print Quality ProblemsDirt on the top edge or back Message Corrective Action Error MessagesEnvelope mode Duplex disabledFormat error Close Rear unitKpdl error Install MKSwitches Job not storedSize error Original toner InstalledMissing Developer unitWrong Account CassetteWrong ID Hard Disk Errors Storage Error CodesCompactFlash CF Card and USB Flash Memory Errors Code MeaningRAM Disk Errors Ready, Data, and Attention IndicatorsIndicatorDescription Possible Paper Jam Locations Clearing Paper JamsPaper jam message Description Reference Location Utilizing Online Help Messages General Considerations for Clearing JamsMP Tray Paper Cassette/Paper Feeder Duplexer Inside the Printer Envelope Feeder Bulk Paper Feeder Rear UnitUsing the Operation Panel General Information GO Key Understanding the Operation PanelMessage Display Error CodesStatus Information Message MeaningReady, Data, and Attention Indicators Indicators in Message DisplayIndicator ReadyCanceling a Printing Job Cancel KeyKeys GO KeyOK Key Cursor KeysEntering the Mode Selection Menu Using the Menu Selection SystemMenu Selection System Cancelling Menu Selection Setting a MenuSelecting a Menu Report Print Setting a Mode Selection MenuPrint Menu Map Report PrintPrint Menu Map ? Menu Map Sample Menu MapPrint Status Page ? Print StatusUnderstanding the Status Firmware Version Print Hard Disk File List Print Fonts ListPrint RAM Disk File List Print Fonts List ?Print Mem. Card File List ? Print Mem. Card File ListPrint File Printing a file USB Memory USB flash memory selectionUSB Memory 00FolderCopies 010 Paper Source ? Cassette Remove Device ? Remove Device Removing the USB flash memoryPrint File List ? Copies Number of copiesJob Retention Job BoxQuick Copy Proof-and-Hold Private Print Stored Job Job Storage Quick Copy Using Quick CopyJob Box Printing Additional Copies using Quick Copy Using Proof-and-HoldDeleting a Quick Copy Job Deleting a Proof-and-Hold Job Printing Remaining Copies of a Proof-and-Hold JobPrivate/Stored ?Harold Arlen ?Agenda Copies Private/Stored Printing a Private Print/Stored JobReleasing a Private/Stored Job Deleting a Private/Stored Job Job Box ConfigurationChanging the Maximum Number of Quick Copy Counter Printed Pages Counter Viewing the counter valuePaper Settings MP Tray Type Setting the MP tray paper type MP Tray Size Setting MP tray paper sizeMP Tray Size ? A4 MP Tray Type Cassette 1 to 4 Size Setting the cassette paper sizeCustom Paper Size Setting the Paper Size from the Operation PanelCassette Size ? Custom Unit Selecting the unit of measurement Unit ? mmEntering the Width and Length Cassette Type Cassette 1 to 4 Type Setting the cassette paper typePaper Weight ? Normal Type Adjust Creating custom paper typeDuplex Path ? Enable Reset Type Adjust ? Reset Type Adjust Resetting the custom paper typeDuplex Path Setting the duplex path Print Settings Print SettingsPaper Source Selecting the paper feed source MP tray Cassette 1 CassettePaper Feed Mode ? Auto Paper Feed Mode Setting the paper feed sourceWhen the Paper Runs Out During Printing Duplex ? Off Duplex Duplex printingCustom 1 to Binding ModesPaper Output Selecting the output stack Emulation Setting the emulationOverride A4/LT Overriding difference between A4 and Letter Paper Output Top tray FaceDn Paper Output ?Top tray FaceDnAlternative Emulation for Kpdl Emulation Emulation ? PCLError Report ? On Font Select Selecting the default fontError Report Printing Kpdl errors Font Select Internal I000Font Select Internal Courier Regular ?Regular Size Points Changing the Default Font SizeSelecting Regular or Dark Courier/Letter Gothic Font Select Internal Pitch 10.00 cpi Cpi Code Set Setting the code setCode Set IBM PC-8 Code Set ?IBM PC-8 Character PitchKIR Mode ? On Print Quality Setting print qualityKIR Mode Selecting the KIR mode Print QualityResolution Selecting the print resolution EcoPrint Mode Selecting the EcoPrint modePrint Density Selecting the print density Set Copies 001 Set Setting paginationOrientation Print orientation CR Action Carriage-Return LF Action LinefeedWide A4 Wide A4 pitch Wide A4 ? Off TCP/IP IPv4 settings Network Network settingsNetwork TCP/IP ? Off IP Address IP address setting Dhcp Dhcp settingDhcp ? Off Gateway Gateway setting Subnet Mask Subnet mask settingBonjour Bonjour setting TCP/IP IPv6 IPv6 settingsBonjour ? Off TCP/IP IPv6 ? Off DHCPv6 DHCPv6 setting RAStateless RA Stateless settingRAStateless ? Off DHCPv6 ? Off MSG Language Selecting the message language Device Common Selecting/Setting the common deviceDevice Common MSG Language ? EnglishKey Confirm. Key confirmation tone setting Buzzer Alarm Buzzer settingJob End Job completed tone setting Buzzer Key Confirm. ? On Job End ? OffReady Preparation completed tone setting Ready ? Off Error ? OnError Error tone setting RAM Disk Mode ? Off RAM Disk Mode Using the RAM diskRAM Disk Size Setting the RAM disk size Hard Disk Using the optional hard diskRAM Disk Size 119MByte Hard DiskFormat ? Memory Card Using the CF cardMemory Card Format Formatting hard diskError Handling Error Handling Error detection settingFormat Formatting CF card Duplex ? Off Paper Mismatch ? On Duplex Duplex printing error detection settingTimer Form Feed Time Out 030sec Timer Timer settingForm Feed Time Out Automatic form feed timeout setting Sleep Timer 030 min Auto Error Clear Auto error clear setting Error Clear Timer 030secMemory overflow Press GO Print overrun Press GO Kpdl error Error Clear Timer Setting the error clear timePanel Reset Timer Setting the panel reset timer Auto Panel Reset Auto panel reset settingsAuto Sleep Setting the sleep timer Security ID Administrator ID inputBlock Interface external device block setting Password Administrator Password inputPassword Block USB Host ? Unblock USB Host USB memory slot settingParallel I/F Parallel interface setting USB Device USB interface settingOption I/F Network interface card setting Frame Type Frame type setting NetWare NetWare settingNetWare ? On Frame Type ? Auto Auto 802.3 Ethernet-II 802.2IPP IPP setting AppleTalk AppleTalk settingAppleTalk AppleTalk ? On IPP ? OffDES SSL Server DES setting SSL Server SSL Server settingSSL Server SSL Server ? Off DES ? Off AES SSL Server AES setting 3DES SSL Server 3DES settingIPP over SSL SSL Server IPP over SSL setting 3DES ? Off AES ? Off IPP over SSL ? OffSecurity Level Security level setting IPSec IPSec settingHttps SSL Server Https setting Https ? Off IPSec IPSec ? OffJob Accounting Job Accounting Job Accounting selection/settingPassword Job Accounting ? Off Enter Account Job Accounting Job Accounting selection/settingJob Accounting enabled Select Account ?00000000 Counter 0000100 Restriction ? Off Select Account Department-specific settingsCounter Account-specific counter management Restriction Print restriction selectionMaximum Output Maximum print output setting Maximum Output Reset Counter?Reset Counter Counter reset Maximum Output appearsDelete Account Department removal Add Account Department registrationAdd Account Delete Account ?001 Print Job Accounting List? Print Job Accounting List Job Accounting list outputAdmin Password Admin Administrator settingsID Administrator ID input Password Administrator Password inputChange Password Administrator Password change Change ID Administrator ID change002 Change Password Change Password appearsPage Adjust/ Maintenance Restart Printer ? Adjust/Maintenance Adjust/Maintenance selection/settingRestart Printer Service Print Status Page ? Print Network Status Page ? Service for maintenancePrint Status Page Printing the service status Print Network Status Page Printing the network statusDrum Setting the drum refleshing mode DRUM-CTRL Setting the automatic drum surface refreshingPrint Test Page ? Developer Initializing the developer unitUsing the Operation Panel Option OptionGeneral Information Expansion Memory Modules Precautions for handling the memory moduleRemoving a Memory Module Installing the Memory ModuleVerifying the expanded memory Remove the right coverPaper Feeder PF-310 CompactFlash CF Card IB-31 Network Interface Cards For FS-2020D PT-310 Faceup Output Tray for FS-3920DN/FS- 4020DNPF-315 Bulk Paper Feeder for FS-3920DN/FS- 4020DN Other OptionsEF-310 Envelope Feeder for FS-3920DN/FS-4020DN HD-5A Hard DiskComputer Interface Interface Signals SpecificationsParallel Interface USB InterfaceNetwork Interface FeaturesEMI Countermeasures Appendix Description FS-2020D FS-3920DN FS-4020DN SpecificationsPDL Prescribe Environmental Standard Requirements Additional memory GlossaryKpdl Sleep mode 11-4 Numerics IndexIndex-2 Index-3 Index-4 Index-5 Index-6 Memo Memo Page Page Rev.1.0

Related manuals

Manual 2 pages 61.19 Kb

Manual 87 pages 18.75 Kb

FS-3920DN specifications

The Kyocera FS-3920DN is a robust and efficient monochrome laser printer designed specifically for small to medium-sized businesses. This multifunctional printer is known for its reliability and high-performance printing capabilities, making it an ideal choice for organizations that require fast, high-quality document output.

One of the standout features of the FS-3920DN is its impressive printing speed. It can produce up to 40 pages per minute (ppm), which significantly enhances productivity, especially in busy office environments where time is of the essence. The first printout is delivered in as little as 5.9 seconds, ensuring that users spend minimal time waiting for documents.

The printer is equipped with a dual-side printing option, which not only helps to save paper but also reduces printing costs. This automatic duplex printing feature is an attractive benefit for companies looking to adopt environmentally friendly practices.

In terms of print quality, the FS-3920DN boasts a resolution of 1200 x 1200 dpi, producing sharp and clear text along with detailed graphics. This makes it suitable for a variety of documentation needs, from simple text documents to more complex reports and presentations.

The printer utilizes Kyocera's advanced toner technology, which results in a longer lifespan and lower cost per page. The eco-friendly ECOSYS technology ensures that the printer is not only efficient but also sustainable, thereby contributing to reduced environmental impact through lower waste generation.

Connectivity options are extensive, with USB and Ethernet ports available for seamless integration into existing networks. Additionally, the FS-3920DN is compatible with mobile printing options, allowing users to print directly from their smartphones and tablets. This flexibility is particularly beneficial in modern office settings where mobility is a key factor.

Moreover, the FS-3920DN's compact design enhances its usability in limited spaces without compromising functionality. Its user-friendly control panel simplifies operation, making it accessible even for those with minimal technical skills.

Overall, the Kyocera FS-3920DN stands out in the competitive landscape of office printers with its blend of high-speed performance, quality output, cost-efficiency, and environmental consideration, making it a smart investment for any enterprise focused on enhancing productivity while maintaining a commitment to sustainability.