NEC LCD1810 user manual Connect the AC Adapter cord to the monitor

Quick Start cont.

3.Connect the BNC cable to the appropriate connectors on the back of the monitor. Connect the red BNC cable to the BNC connector on the monitor labeled R, the green

BNC cable to the BNC connector labeled G (/SYNC), the blue BNC cable to the BNC connector labeled B. If you require a fourth BNC connector (Composite Sync), connect it to the BNC connector on the monitor labeled HS/CS. If you require a fifth BNC connector (Vertical Sync), connect it to the BNC connector on the monitor labeled VS (Figure C.1). Connect the other end to the computer. For a PC refer to (Figure A.2). For a Macintosh refer to (Figure B.2).

NOTE: Incorrect cable connections may result in irregular	R
operation or damage display components.

4.	Connect the AC Adapter cord to the monitor	G(/SYNC)
5.	(Figure D.1).	B
	Connect one end of the power cord to the AC
	adapter and the other end to the power outlet	HS/CS
	(Figure E.1).
6.	Turn on the monitor (Figure F.1) and the computer.	VS
7.	To complete the setup of your MultiSync®
	LCD monitor:
	A. Set the resolution to 1280 x 1024 @ 60 Hz.

NOTE: For download information on the Windows®
	95/98 INF file for your MultiSync LCD	Figure C.1
	monitor, refer to the References section
	of this User’s Manual.
	B. Use the following OSM™ controls:
	• Auto Adjust Contrast
	• Auto Adjust
NOTE: Manual adjustment of the H/V Position and
	Image Adjust H. Size/Fine controls may be
	required to complete setup of your
	MultiSync monitor. For a full description of
	these OSM controls, refer to the Controls
8.	section of this User’s Manual.	Figure D.1
	Refer to User’s Manual in the NEC LCD Setup
	Software CD case for installation and operation
	of this software.

NOTE: If you have any problems, please refer to the

Troubleshooting section of the User’s Manual.

Power

Button

Figure E.1

Figure F.1

5

78133813.wpc 7 10/28/99, 3:21 PM