NEC P600 manual Removing the inverter board screws

Page 16

Fig. 24 Removing the inverter board screws

4.Carefully lift up LCD panel and disconnect the LCD cable from the penal.

5.Remove the screws at both sides of the LCD panel in order to release the LCD hinges as shown in Fig. 25 .

Fig. 25 Removing the LCD Panel hinges

M2x5 Silver

M2x3.5 Silver

NEC Versa P600 Disassembly Manual

Page 16

Image 16

Contents NEC Table of contents Disassembly Instructions Reassembly InstructionsOverview Technician NotesHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge Removing the Battery Removing the Hard Disk DriveDisconnecting the hard disk drive Removing the MDC Modem ModuleRemoving the Keyboard Cover Removing the KeyboardRemoving the Optical drive & Heat plate Removing the screws holding the keyboardCarefully remove the heat plate from the base unit Removing the Memory Module Removing Heat plate from base unitRemoving the Wireless Module Removing Heat Sink & CPUReleasing the heat sink screws Disconnecting the LCD & speaker connectors Removing the LCD ModuleLCD hinge screws at the rear Removing the LCD Panel AaaaRemoving the inverter board screws Removing the Top Cover Removing the Top cover screwsBattery Compartment Removing the Touch PadTouch Pad Assembly Removing the DC/DC Board DC/DC BoardRemoving the Main Board Removing the main board screwsDIP Switch Setting Dip Switch Description SeetingScrews Versa P600 Disassembly Manual