Removing the Main Board
To remove the Main board, first open the Top Cover (see Removing the Top Cover), remove DC/DC board (see Removing DC/DC board) then perform the following steps:
1. Remove the screws holding the main board in place as shown in Fig. 33
A
B
A
Fig. 33 Removing the main board screws
2. Disconnect the VGA connector from the base as shown in Fig. 34
Fig. 34 Disconnecting the VGA connector
3. Lift the main board out of the system and put it aside (Fig. 35 ).
A = M2x5
Silver
B = M2.5x8
Silver
M2.5x10 silver
NEC Versa P600 Disassembly Manual | Page 21 |