NEC P600 manual Removing the Touch Pad, Battery Compartment

Page 18

Fig. 28 Battery Compartment

5. Carefully lift up and release the top cover and put it aside.

Fig. 29 Removing the top cover

Note: Remember to disconnect the touch pad cable before lifting up the top cover. On the VGA connector area use extra care to release the top cover.

Removing the Touch Pad

To remove the Touch Pad, first remove the Top Cover (see Removing the Top Cover), then perform the following steps:

M2x3 Sliver

NEC Versa P600 Disassembly Manual

Page 18

Image 18

Contents NEC Table of contents Overview Disassembly InstructionsReassembly Instructions Technician NotesPower Supply Unit Hazardous VoltageAvoid Electrostatic Discharge Removing the Battery Removing the Hard Disk DriveDisconnecting the hard disk drive Removing the MDC Modem ModuleRemoving the Keyboard Cover Removing the KeyboardRemoving the Optical drive & Heat plate Removing the screws holding the keyboardCarefully remove the heat plate from the base unit Removing the Memory Module Removing Heat plate from base unitRemoving the Wireless Module Removing Heat Sink & CPUReleasing the heat sink screws Disconnecting the LCD & speaker connectors Removing the LCD ModuleLCD hinge screws at the rear Removing the LCD Panel AaaaRemoving the inverter board screws Removing the Top Cover Removing the Top cover screwsBattery Compartment Removing the Touch PadTouch Pad Assembly Removing the DC/DC Board DC/DC BoardRemoving the Main Board Removing the main board screwsDIP Switch Setting Dip Switch Description SeetingScrews Versa P600 Disassembly Manual