NEC P600 manual Removing the Keyboard Cover

Page 7

2.Carefully lift up MDC modem module.

3.Disconnect the cable attached to the MDC modem and put the modem aside.

Removing the Keyboard Cover

To remove the Keyboard Cover , first remove the battery (see Removing the Battery), then perform the following steps:

1. Remove the screw as shown in Fig. 6

Fig. 6 Removing Keyboard Cover screws

2. Remove the Keyboard Cover as shown in Fig. 7

Fig. 7 Removing the Keyboard Cover

Removing the Keyboard

To remove the Keyboard module, first remove the keyboard cover (see Removing keyboard cover), then perform the following steps:

M2x15 Black

NEC Versa P600 Disassembly Manual

Page 7

Image 7
Contents NEC Table of contents Technician Notes Disassembly InstructionsReassembly Instructions OverviewHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge Removing the Hard Disk Drive Removing the BatteryRemoving the MDC Modem Module Disconnecting the hard disk driveRemoving the Keyboard Removing the Keyboard CoverRemoving the screws holding the keyboard Removing the Optical drive & Heat plateCarefully remove the heat plate from the base unit Removing Heat plate from base unit Removing the Memory ModuleRemoving Heat Sink & CPU Removing the Wireless ModuleReleasing the heat sink screws Removing the LCD Module Disconnecting the LCD & speaker connectorsLCD hinge screws at the rear Aaaa Removing the LCD PanelRemoving the inverter board screws Removing the Top cover screws Removing the Top CoverRemoving the Touch Pad Battery CompartmentTouch Pad Assembly DC/DC Board Removing the DC/DC BoardRemoving the main board screws Removing the Main BoardDip Switch Description Seeting DIP Switch SettingScrews Versa P600 Disassembly Manual