NEC P600 manual LCD hinge screws at the rear

Page 14

Fig. 20 LCD hinge screws at the rear

4. Unscrew the two screws located on the bottom of the unit as shown in Fig. 21

Fig. 21 LCD hinge screws at the bottom

5. Carefully lift the LCD module out of the system and put it aside.

M2x6 Black

M2x6 Black

NEC Versa P600 Disassembly Manual

Page 14

Image 14

Contents NEC Table of contents Overview Disassembly InstructionsReassembly Instructions Technician NotesAvoid Electrostatic Discharge Power Supply UnitHazardous Voltage Removing the Battery Removing the Hard Disk DriveDisconnecting the hard disk drive Removing the MDC Modem ModuleRemoving the Keyboard Cover Removing the KeyboardRemoving the Optical drive & Heat plate Removing the screws holding the keyboardCarefully remove the heat plate from the base unit Removing the Memory Module Removing Heat plate from base unitRemoving the Wireless Module Removing Heat Sink & CPUReleasing the heat sink screws Disconnecting the LCD & speaker connectors Removing the LCD ModuleLCD hinge screws at the rear Removing the LCD Panel AaaaRemoving the inverter board screws Removing the Top Cover Removing the Top cover screwsBattery Compartment Removing the Touch PadTouch Pad Assembly Removing the DC/DC Board DC/DC BoardRemoving the Main Board Removing the main board screwsDIP Switch Setting Dip Switch Description SeetingScrews Versa P600 Disassembly Manual