NEC L234GC, LCD2335WXM Connecting to a Antenna / Cable, Precautions when connecting the antenna

Page 10

Installation Instructions continued

Connecting to a Antenna / Cable

Make sure that the power switch of the LCD MONITOR is turned off and that the unit is disconnected from the AC power source.

Monitor rear panel

Antenna

Precautions when connecting the antenna

z Use a coaxial cable which is free from interference. Avoid using a parallel flat wire as interference may occur, causing the reception to become unstable and noise to appear on the screen.

zAvoid using an indoor antenna as this may be affected by interference and poor reception.

zKeep the power cord as far away from the antenna wire as possible.

zAuto Tuning please refer to page 24

VHF(300-Ohm) antenna / UHF antenna

When using a 300-ohm twin lead from an outdoor antenna, connect the VHF or UHF antenna leads to the screws of the VHF or UHF adapter. Plug the 300-ohm to 75-ohm adapter into the antenna on the LCD MONITOR.

When both VHF and UHF antennas are combined

Attach an optional antenna cable signal combiner to the LCD MONITOR antenna terminal, and connect the cables to the antenna mixer. Consult your local electronics retailer about available signal combiners.

Reconnect the unit to the AX power source and turn on the power.

Using the Remote Control or User Controls, select the "CHANNEL SETTING MENU". Select the appropriate menu based upon which source (cable or antenna) is being used.

Refer to pages 15 and 16 for further information on the "CHANNEL SETTING MENU" as well as for information on how to use the "AUTO PROGRAM" function to program available channels.

8

Image 10

Contents LCD2335WXMTM Index Important Information Canadian Department of Communications Compliance StatementCleaning the LCD Panel Safety Precautions, Maintenance & Recom- mended UseCleaning the Cabinet Contents Front view of main body Component Names and FunctionsMain Unit Rear view of main bodyInstalling the batteries Remote ControlOpen the battery cover Close the battery coverRemote Control SourceDetaching Main Body From Its Stand Installation InstructionsViewing Angle Adjustment Interface for Arm ApplicationsWhen both VHF and UHF antennas are combined Connecting to a Antenna / CablePrecautions when connecting the antenna VHF300-Ohm antenna / UHF antennaTerminal Connecting to a Video ComponentsSub Remarks Connecting to a PC Prevention of Screen BurnPower lamp Turning Power On and OffPower Operation Lamp Operating InstructionsSelecting AV Inputs Volume AdjustmentAudio Mute Selected Setup hint Characters Picture ParametersAudio Setting PC ParametersAuto Program setting Channel SettingFine Tune setting Channel Edit setting Panoramic Aspect mode Select 43 and 169 aspect modeThere are 4 selections CinemaSelected Setup hint Picture-in-PictureSource PIP Picture in PictureSelecting PIP size Large PIP Position Small Medium PBPSelect PIP size Setting Up PIP through On Screen Main MenuMain Select PIP SourceChange PIP Position PICTUREIN PictureMulti PIP Stereo sound Other FunctionsMono and SAP 2nd Audio program sound program Stereo and SAP 2nd Audio program sound programParental Controls Mpaa RatingMpaa Rating Motion Picture Ratings ChartTV PG Rating TV Parental Guide Ratings Chart General Setting BOX Captions MenuTEX1---TEXT2 ShadowFeatures Troubleshooting NopictureAdjust them for higher contrast and brightness Check to see that the signal cable is properly ConnectedCheck Contrast and brightness Settings Phase next. RGB inputSymptom Point to check Symptoms Symptom Possible reason RemedyNEC-MitsubishiMonitorCustomerService&Support ReferencesSpecifications PC InputLimited Warranty TCO’99 TCO’99 DeclarationoftheManufacturer NEC LCD2335WXM