NEC LCD2335WXM, L234GC manual Installation Instructions, Viewing Angle Adjustment

Page 9

Installation Instructions

Viewing Angle Adjustment

This product is designed to allow users to have a comfortable viewing angle. The viewing angle can be adjusted from -5°to +20°.

Warning: Do not force the LCD Monitor over its maximum viewing angle as stated above. Attempting this will result in damaging the Monitor and Monitor stand.

Detaching Main Body From Its Stand

Important: Place the monitor on a clean, flat surface that will not scratch the front or glass surfaces of the display unit.

1.Remove the rear cover from rear stand assembly

2.Remove the 5 screws from the hinge bracket

3.Remove the stand from main body

Interface for Arm Applications

Before installing to mounting device, please refer to Fig.1-5.

The rear of this LCD display has four integrated 4 mm, 0.7 pitches threaded nuts, as well as four 5 mm access holes in the plastic covering as illustrated in Figure 1-

8.These specifications meet the VESA Flat Panel Monitor Physical Mounting Interface Standard (paragraphs 2.1 and 2.1.3, version 1, dated 13 November 1997).

Note 1: Please using Ø 4mm x 8mm (L) screw for this application.

Note 2: The LCD monitor should only be used with an approved arm (e.g. GS mark). To meet the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor.

1

2

100mm x 100mm

Screw Mounting Options

100mm

100mm

4mm ,0.7pitch threaded holes x4

7

Image 9

Contents LCD2335WXMTM Index Canadian Department of Communications Compliance Statement Important InformationSafety Precautions, Maintenance & Recom- mended Use Cleaning the LCD PanelCleaning the Cabinet Contents Main Unit Component Names and FunctionsFront view of main body Rear view of main bodyOpen the battery cover Remote ControlInstalling the batteries Close the battery coverSource Remote ControlViewing Angle Adjustment Installation InstructionsDetaching Main Body From Its Stand Interface for Arm ApplicationsPrecautions when connecting the antenna Connecting to a Antenna / CableWhen both VHF and UHF antennas are combined VHF300-Ohm antenna / UHF antennaConnecting to a Video Components TerminalSub Remarks Prevention of Screen Burn Connecting to a PCPower Operation Lamp Turning Power On and OffPower lamp Operating InstructionsVolume Adjustment Selecting AV InputsAudio Mute Picture Parameters Selected Setup hint CharactersPC Parameters Audio SettingChannel Setting Auto Program settingFine Tune setting Channel Edit setting There are 4 selections Aspect mode Select 43 and 169 aspect modePanoramic CinemaPicture-in-Picture Selected Setup hintSelecting PIP size Picture in PictureSource PIP Large PIP Position Small Medium PBPMain Setting Up PIP through On Screen Main MenuSelect PIP size Select PIP SourcePICTUREIN Picture Change PIP PositionMulti PIP Mono and SAP 2nd Audio program sound program Other FunctionsStereo sound Stereo and SAP 2nd Audio program sound programMpaa Rating Parental ControlsMotion Picture Ratings Chart Mpaa RatingTV PG Rating TV Parental Guide Ratings Chart General Setting TEX1---TEXT2 Captions MenuBOX ShadowFeatures Nopicture TroubleshootingCheck Contrast and brightness Settings Check to see that the signal cable is properly ConnectedAdjust them for higher contrast and brightness Phase next. RGB inputSymptom Point to check Symptom Possible reason Remedy SymptomsReferences NEC-MitsubishiMonitorCustomerService&SupportPC Input SpecificationsLimited Warranty TCO’99 TCO’99 DeclarationoftheManufacturer NEC LCD2335WXM