NEC LCD2335WXM Operating Instructions, Turning Power On and Off, Power Operation Lamp, Power lamp

Page 13

Operating Instructions

Power Lamp

POWER button

POWER ON/OFF button

Turning Power On and Off

To turn the LCD MONITOR power ON/OFF, press the POWER button or the ON/OFF button on the remote control.

The power lamp will light and turn to green, the LCD MONITOR will turn on.

zNote: During normal use, the main power switch is set in the ON position.

Power lamp

	Power	Power	Operation
	lamp	lamp	Operation
	lamp	lamp
	Off	Off	The OFF button on the remote control or
	Off	Off	the POWER button is OFF.
			the POWER button is OFF.
			When the power switch is ON, and the
	Lights green	On	ON button on the remote control or the
			POWER button is ON.
	Lights orange	On	When the power switch is ON, and the
	Lights orange	On	PC is in power save mode.
			PC is in power save mode.

When the indicator lamp lights orange or the message “No cable connected” or “Going to sleep” appears on the screen, there is something abnormal about the status of the reception. See Trouble Shooting.

CAUTION

z Avoid repeatedly turning the LCD MONITOR on and off at short time intervals. Failures might result from doing so.

z If a power failure occurs while the main unit is running, it will be powered on upon recovery from the failure. To prevent the power from returning unexpectedly, possibly causing damage, turn off the main power switch when after power failure occurs. Unplug the AC power source to the AC adapter for 30 seconds to reset the unit.

11

Image 13

Contents LCD2335WXMTM Index Canadian Department of Communications Compliance Statement Important InformationCleaning the LCD Panel Safety Precautions, Maintenance & Recom- mended UseCleaning the Cabinet Contents Main Unit Component Names and FunctionsFront view of main body Rear view of main bodyOpen the battery cover Remote ControlInstalling the batteries Close the battery coverSource Remote ControlViewing Angle Adjustment Installation InstructionsDetaching Main Body From Its Stand Interface for Arm ApplicationsPrecautions when connecting the antenna Connecting to a Antenna / CableWhen both VHF and UHF antennas are combined VHF300-Ohm antenna / UHF antennaTerminal Connecting to a Video ComponentsSub Remarks Prevention of Screen Burn Connecting to a PCPower Operation Lamp Turning Power On and OffPower lamp Operating InstructionsSelecting AV Inputs Volume AdjustmentAudio Mute Picture Parameters Selected Setup hint CharactersPC Parameters Audio SettingAuto Program setting Channel SettingFine Tune setting Channel Edit setting There are 4 selections Aspect mode Select 43 and 169 aspect modePanoramic CinemaPicture-in-Picture Selected Setup hintSelecting PIP size Picture in PictureSource PIP Large PIP Position Small Medium PBPMain Setting Up PIP through On Screen Main MenuSelect PIP size Select PIP SourceChange PIP Position PICTUREIN PictureMulti PIP Mono and SAP 2nd Audio program sound program Other FunctionsStereo sound Stereo and SAP 2nd Audio program sound programMpaa Rating Parental ControlsMpaa Rating Motion Picture Ratings ChartTV PG Rating TV Parental Guide Ratings Chart General Setting TEX1---TEXT2 Captions MenuBOX ShadowFeatures Nopicture TroubleshootingCheck Contrast and brightness Settings Check to see that the signal cable is properly ConnectedAdjust them for higher contrast and brightness Phase next. RGB inputSymptom Point to check Symptom Possible reason Remedy SymptomsReferences NEC-MitsubishiMonitorCustomerService&SupportPC Input SpecificationsLimited Warranty TCO’99 TCO’99 DeclarationoftheManufacturer NEC LCD2335WXM