NEC L234GC, LCD2335WXM manual Selecting AV Inputs, Volume Adjustment, Audio Mute

Page 14

Operating Instructions continued

SOURCE button	VOLUME buttons
TV>AV>PC	ENTER	CH	MENU

TV

SOURCE

VOLUME control

MUTE

AV1, AV2, AV3

RGB1, RGB2,

AV4 buttons

Selecting AV Inputs

zInput can be switched by pressing the AV1, AV2, AV3, AV4,

RGB1, or RGB2 buttons

zInput can be switched in the sequence TVJAV1 JAV2J AV3

JAV4 J RGB1 VGA J RGB2 DVI by pressing the SOURCE button and then select the Input with the select keys

STand then press the ENTER button.To select a TV station, press the TV button.

TV AV1 AV2 AV3

RGB2 DVI RGB1 VGA AV4

Volume Adjustment

The volume can be adjusted by pressing the S and T buttons of the remote control.

Volume setting value

Adjustment status guide

zWhen the volume buttons are pressed, the volume adjustment status guide will be displayed.

zThe volume will increase when the VOL+ (or S) button is pressed while the guide is being displayed.

zThe volume will decrease when the VOL- (or T) button is pressed while the guide is being displayed.

Audio Mute

The audio volume can be temporarily muted by pressing the MUTE button of the remote control.

When the MUTE button is pressed, the above icon will appear.

z The volume setting can be lowered by pressing the VOL- button while the audio is muted.

z Muting can be cancelled by pressing the VOL+ button or the MUTE button while the audio is muted.

12

Image 14

Contents LCD2335WXMTM Index Important Information Canadian Department of Communications Compliance StatementCleaning the Cabinet Safety Precautions, Maintenance & Recom- mended UseCleaning the LCD Panel Contents Front view of main body Component Names and FunctionsMain Unit Rear view of main bodyInstalling the batteries Remote ControlOpen the battery cover Close the battery coverRemote Control SourceDetaching Main Body From Its Stand Installation InstructionsViewing Angle Adjustment Interface for Arm ApplicationsWhen both VHF and UHF antennas are combined Connecting to a Antenna / CablePrecautions when connecting the antenna VHF300-Ohm antenna / UHF antennaSub Remarks Connecting to a Video ComponentsTerminal Connecting to a PC Prevention of Screen BurnPower lamp Turning Power On and OffPower Operation Lamp Operating InstructionsAudio Mute Volume AdjustmentSelecting AV Inputs Selected Setup hint Characters Picture ParametersAudio Setting PC ParametersFine Tune setting Channel SettingAuto Program setting Channel Edit setting Panoramic Aspect mode Select 43 and 169 aspect modeThere are 4 selections CinemaSelected Setup hint Picture-in-PictureSource PIP Picture in PictureSelecting PIP size Large PIP Position Small Medium PBPSelect PIP size Setting Up PIP through On Screen Main MenuMain Select PIP SourceMulti PIP PICTUREIN PictureChange PIP Position Stereo sound Other FunctionsMono and SAP 2nd Audio program sound program Stereo and SAP 2nd Audio program sound programParental Controls Mpaa RatingTV PG Rating Motion Picture Ratings ChartMpaa Rating TV Parental Guide Ratings Chart General Setting BOX Captions MenuTEX1---TEXT2 ShadowFeatures Troubleshooting NopictureAdjust them for higher contrast and brightness Check to see that the signal cable is properly ConnectedCheck Contrast and brightness Settings Phase next. RGB inputSymptom Point to check Symptoms Symptom Possible reason RemedyNEC-MitsubishiMonitorCustomerService&Support ReferencesSpecifications PC InputLimited Warranty TCO’99 TCO’99 DeclarationoftheManufacturer NEC LCD2335WXM