NEC LCD2335WXM, L234GC manual Channel Setting, Auto Program setting, Fine Tune setting

Page 17

Operating Instructions continued

Channel Setting

*Note: The TV must be in TV mode for access to this Menu.

When operating the TV at first time, its TV system is at “default factory mode” and this mode cannot display the image normally on the screen. In order to watch the TV program without problem, please refer to the follow steps to setup the TV system accordingly for normally display 1.SYSTEM setting: Select between antenna or cable (STD / HRC / IRC) TV system

SYSTEM

AUTO PROGRAM

FINE TUNE

ANTENNA

CABLE

CHANNEL EDIT

ANTENNA

CABLE

TV 12

ANTENNA		STD

CABLE	STD	HRC

STD 12

HRC

IRC

IRC

STD

HRC

IRC

				STD
				HRC
SELECT:	ENTER:	ADJUST:	RETURN: MENU	IRC

2.Auto Program setting

AUTO PROGRAM:Auto search channels

HRC 12

IRC 12

SYSTEM

AUTO PROGRAM

FINE TUNE

CHANNEL EDIT

SELECT:	ENTER:			ADJUST:	RETURN: MENU

3.FINE TUNE setting

AUTO: Use AUTO function to fine tune screen

MANUAL: Use MANUAL function to fine tune screen

SYSTEM
AUTO PROGRAM
FINE TUNE	AUTO
	AUTO
CHANNEL EDIT	MENU
	MENU
SYSTEM
AUTO PROGRAM
FINE TUNE	AUTO
	AUTO
CHANNEL EDIT	MENU
	MENU

Note: Not all menus are available for every input source.

15

Image 17

Contents LCD2335WXMTM Index Canadian Department of Communications Compliance Statement Important InformationCleaning the Cabinet Safety Precautions, Maintenance & Recom- mended UseCleaning the LCD Panel Contents Main Unit Component Names and FunctionsFront view of main body Rear view of main bodyOpen the battery cover Remote ControlInstalling the batteries Close the battery coverSource Remote ControlViewing Angle Adjustment Installation InstructionsDetaching Main Body From Its Stand Interface for Arm ApplicationsPrecautions when connecting the antenna Connecting to a Antenna / CableWhen both VHF and UHF antennas are combined VHF300-Ohm antenna / UHF antennaSub Remarks Connecting to a Video ComponentsTerminal Prevention of Screen Burn Connecting to a PCPower Operation Lamp Turning Power On and OffPower lamp Operating InstructionsAudio Mute Volume AdjustmentSelecting AV Inputs Picture Parameters Selected Setup hint CharactersPC Parameters Audio SettingFine Tune setting Channel SettingAuto Program setting Channel Edit setting There are 4 selections Aspect mode Select 43 and 169 aspect modePanoramic CinemaPicture-in-Picture Selected Setup hintSelecting PIP size Picture in PictureSource PIP Large PIP Position Small Medium PBPMain Setting Up PIP through On Screen Main MenuSelect PIP size Select PIP SourceMulti PIP PICTUREIN PictureChange PIP Position Mono and SAP 2nd Audio program sound program Other FunctionsStereo sound Stereo and SAP 2nd Audio program sound programMpaa Rating Parental ControlsTV PG Rating Motion Picture Ratings ChartMpaa Rating TV Parental Guide Ratings Chart General Setting TEX1---TEXT2 Captions MenuBOX ShadowFeatures Nopicture TroubleshootingCheck Contrast and brightness Settings Check to see that the signal cable is properly ConnectedAdjust them for higher contrast and brightness Phase next. RGB inputSymptom Point to check Symptom Possible reason Remedy SymptomsReferences NEC-MitsubishiMonitorCustomerService&SupportPC Input SpecificationsLimited Warranty TCO’99 TCO’99 DeclarationoftheManufacturer NEC LCD2335WXM