Lexmark 752 setup guide Installing a memory card, What do I do now?

Page 33

Installing a memory card

Note: Some memory options offered for other Lexmark printers cannot be used with your printer. Refer to the publications CD for memory specifications.

Warning: Memory cards are easily damaged by static electricity. Touch something metal on the printer before you touch a card.

Latch

Notch

Connection points

Follow the instructions in this section to install a printer memory card. Memory cards must have 168-pin connectors.

1 Remove the system board access cover (see Page 22).

2 Unpack the memory card.

Avoid touching the connection points along the edge of the card. Save the packaging.

3 Push open the latches on both ends of the memory connector.

4 Align the notches on the bottom of the card with the notches on the connector.

5 Push the memory card firmly into the connector until the latches on either end of the connector snap into place.

It may require some force to fully seat the card.

6 Make sure each latch fits over the notch on the end of the card.

What do I do now?

Task	Go to page…

Installing a firmware card	25

Installing a hard disk	26

Installing an option card	28

Replacing the system board access cover	30

Install memory, firmware, or option cards

24

Image 33

Contents C752 Page English Edition June Contents Install drivers for local printing About your printer IntroductionPublications CD Quick Reference pages Other sources of informationQuick Reference and Clearing Jams sheets Drivers CDLexmark’s Web site Setting up a multifunction printer Unpack the printerUnpacking Power cord Drivers CD You may have purchased Set up the printer and paper handling optionsInstalling a 2000-sheet drawer Leveling feet Installing a 500-sheet drawer Installing a duplex unit Positioning the printer Set up the printer and paper handling options Installing an output expander Set up the printer and paper handling options Installing a 5-bin mailbox Set up the printer and paper handling options Setting up the print cartridges Set up the print suppliesGuides Detensioner Set up the print supplies Set up the print supplies Attaching an adhesive operator panel overlay What do I do next? Install memory, firmware, or option cards Removing the system board access cover Use the following table to locate the instructions you need What do I do now? Installing a memory cardInstalling a firmware card Installing a hard disk What do I do now? Card Function Installing an option cardSecure the card to the system board with the screw Install memory, firmware, or option cards Load paper Loading the 500-sheet trays Maximum height guide Loading the 2000-sheet tray LT.LG Loading the multipurpose feeder Load paper Load paper Attaching a local cable Attach cables and power cordAttach cables and power cord Serial ParallelEthernet Attaching a network cableFiber optic 802.11b wireless options Operating system Cable Go to Install drivers for local printingWindows Using Windows Me Using WindowsWith USB or Parallel cableUsing Windows 98 with a USB or parallel cable Page Creating a desktop printer icon Macintosh MacintoshCreating a queue in Print Center Macintosh OS UNIX/Linux Printing a menu settings Verify printer setupVerify printer setup Assigning a printer IP address Configure for TCP/IPPing Verifying the IP settings Configuring for Pull PrintingSupported printer drivers Install drivers for network printingClick Install Printer and Software Install a custom printer driver Install the printer driver or subset on network clients Macintosh Mac OS 8.6 to Install a custom PPD fileCreate a print queue in Print Center Mac OS X version 10.1.2 and laterUNIX/Linux NetWare Viewing and using the CD contents Congratulations Using the publications CD