Oki BMG7011, BMG7012 manual Napt Configuration, Port Forwarding

Page 30

BMG7011 and BMG7012 User’s Guide Rev. 1.9

3.5NAPT Configuration

3.5.1Port Forwarding

You can add or delete Port Forwarding Rule to the device in Gateway mode. When the packet travels through the gateway, if the port of the packet matches the port of port-forwarding rule, then packet will be forwarded to the private IP address configured of the matched rule.

 

Figure 14 – Port Forwarding Rule/Rule Table Window

 

 

 

Item

 

Description

 

 

 

Tcp/udp/both

 

Select if you want to forward the packet based on tcp, udp or both

Forward Port

 

The tcp or udp port number for which you want to forward

To Private IP

 

The IP Address of the pc in the LAN side is forwarding to

ID

 

The ID of the port forwarding rule is to be deleted

Rule Table

 

Maximum of 10 forwarding together with IP Filtering can be specified

© Copyright, 2004 Oki Network Technologies. All Rights Reserved

25

Image 30
Contents Broadband Media Gateway Document Revision History Copyrights Notice Contents 11.1 Package Contents FeaturesSystem Requirements Integrated Routing Features Hardware Installation Front View LEDsRear View Ports LineInitial Installation Procedures for Adsl and Cable Networks Configuring TCP/IP Protocol for Your PCConfiguring the BMG7011 and BMG7012 VoIP gateways Configuring via Web BrowserSupervisor Mode Setting your BMG to communicate through PPPoEBMG7011 and BMG7012 User’s Guide Rev Setting your BMG to communicate through Dhcp Select Dhcp within the WAN Configuration setup screen Setting your BMG to communicate through a Static IP address Installation Overview For Adsl and Cable Networks Example DSL installationPHONE1 & PHONE2 Web Interface Screen Descriptions Status System StatusPort Status Port Status WindowDhcpc Status DNSPPPoE Status PPPoE Status Window DescriptionPPPoE Configuration DescriptionDhcp Server Configuration Dhcp ConfigurationWAN Configuration WAN IPDescription Remote ProvisioningDevice Mode Device Mode Configuration WindowNTP 1 NTPNapt Configuration Port ForwardingIP Filter Configuration Window IP FilteringDMZ Configuration Window 3 DMZQoS Configuration QoSDscp Configuration VLan Configuration Mac Cloning Mac Cloning WindowPstn Configuration Switch KeyDigit Map LengthProvision Configuration GroupSyslog Configuration Syslog Configuration WindowEMS Configuration 11.1 EMSSnmp Community Configuration Window Snmp CommunitySnmp Trap Configuration Window Snmp Trap TargetVoIP Configuration ProtocolDescription UserMgcp RstpVoIP SIP Configuration Window 12.4 SIPSIP Domain Specifies the password for secured registration 12.5 H.323Dtmf Description CodecBMG7011 and BMG7012 User’s Guide Rev VoIP Caller ID Configuration Window 12.8 RTP RTP portTone Busy ToneCall Waiting Tone VoIP Fax Configuration Window 12.10 FAXStun NAT AddressSpeed Dial Add/ModifyCall Features Port Configure port 1 or port 2 For BMG7012 Only Call HoldPhone book Password Configuration Supervisor PasswordUser Password User Password WindowUpgrade Configuration FirmwareConfiguration Configuration Upgrade WindowSave Configuration SaveLoad Default Settings Load Default Settings WindowReboot Reboot WindowAppendix a Troubleshooting Appendix B Specifications