Oki BMG7011, BMG7012 manual Digit Map, Length

Page 38

BMG7011 and BMG7012 User’s Guide Rev. 1.9

3.8.2Digit Map

This function allows user to set the Digit Map. User can set up a list of numbers with specific prefix and total length of phone number to switch from VoIP mode to PSTN mode. When user enters in specific, predefined phone numbers, the BMG gateway will automatically send these calls over the PSTN.

 

Figure 22 –PSTN Digitmap Window

 

 

Item

Description

 

 

Prefix

Enter the prefix of the telephone number. The maximum length is 15 digits.

Length

Enter the total length of the telephone number. The length is ranged from 0~64. “0” means the

 

length is not fixed.

Add/Modify

Add or modify your desired prefix and length of the telephone number with 15 maximum entries

Delete

Delete an existing prefix and length of the telephone number from the Digit Map Table

Refresh

Press this button will show new changes

© Copyright, 2004 Oki Network Technologies. All Rights Reserved

33

Image 38
Contents Broadband Media Gateway Document Revision History Copyrights Notice Contents 11.1 System Requirements Package ContentsFeatures Integrated Routing Features Hardware Installation Front View LEDsRear View Ports LineInitial Installation Procedures for Adsl and Cable Networks Configuring TCP/IP Protocol for Your PCConfiguring the BMG7011 and BMG7012 VoIP gateways Configuring via Web BrowserSupervisor Mode Setting your BMG to communicate through PPPoEBMG7011 and BMG7012 User’s Guide Rev Setting your BMG to communicate through Dhcp Select Dhcp within the WAN Configuration setup screen Setting your BMG to communicate through a Static IP address Installation Overview For Adsl and Cable Networks Example DSL installationPHONE1 & PHONE2 Web Interface Screen Descriptions Status System StatusPort Status Port Status WindowDhcpc Status DNSPPPoE Status PPPoE Status Window DescriptionPPPoE Configuration DescriptionDhcp Server Configuration Dhcp ConfigurationWAN Configuration WAN IPDescription Remote ProvisioningDevice Mode Device Mode Configuration WindowNTP 1 NTPNapt Configuration Port ForwardingIP Filter Configuration Window IP FilteringDMZ Configuration Window 3 DMZQoS Configuration QoSDscp Configuration VLan Configuration Mac Cloning Mac Cloning WindowPstn Configuration Switch KeyDigit Map LengthProvision Configuration GroupSyslog Configuration Syslog Configuration WindowEMS Configuration 11.1 EMSSnmp Community Configuration Window Snmp CommunitySnmp Trap Configuration Window Snmp Trap TargetVoIP Configuration ProtocolDescription UserMgcp RstpVoIP SIP Configuration Window 12.4 SIPSIP Domain Specifies the password for secured registration 12.5 H.323Dtmf Description CodecBMG7011 and BMG7012 User’s Guide Rev VoIP Caller ID Configuration Window 12.8 RTP RTP portTone Busy ToneCall Waiting Tone VoIP Fax Configuration Window 12.10 FAXStun NAT AddressSpeed Dial Add/ModifyCall Features Port Configure port 1 or port 2 For BMG7012 Only Call HoldPhone book Password Configuration Supervisor PasswordUser Password User Password WindowUpgrade Configuration FirmwareConfiguration Configuration Upgrade WindowSave Configuration SaveLoad Default Settings Load Default Settings WindowReboot Reboot WindowAppendix a Troubleshooting Appendix B Specifications