Oki BMG7012, BMG7011 manual 12.4 SIP, VoIP SIP Configuration Window

Page 47

BMG7011 and BMG7012 User’s Guide Rev. 1.9

disconnected from the Call Agent.

3.12.4SIP

This screen allows you to make SIP configurations including local port, SIP proxy server address, port number, registrar server address, port number, expiry time, SIP domain, and subject. Save and Reboot.

 

Figure 31 – VoIP SIP Configuration Window

 

 

Item

Description

 

 

Local Port

Specifies the port number of the SIP stack. 5060 is the default port number.

Proxy Address

Specifies the IP address of SIP proxy server

Proxy Port

Specifies the port number of SIP proxy server

Registrar Address

Specifies the IP address of Registrar server. Registrar server is often the same as SIP proxy server

Registrar Port

Specifies the port number of Registrar server.

Expires

“Expires” specifies the period (in seconds) that the VoIP Gateway sends Registration message to

 

Registrar server. This is to help check the connection status in case the VoIP Gateway is

© Copyright, 2004 Oki Network Technologies. All Rights Reserved

42

Image 47
Contents Broadband Media Gateway Document Revision History Copyrights Notice Contents 11.1 System Requirements Package ContentsFeatures Integrated Routing Features Front View LEDs Hardware InstallationLine Rear View PortsConfiguring TCP/IP Protocol for Your PC Initial Installation Procedures for Adsl and Cable NetworksConfiguring via Web Browser Configuring the BMG7011 and BMG7012 VoIP gatewaysSetting your BMG to communicate through PPPoE Supervisor ModeBMG7011 and BMG7012 User’s Guide Rev Setting your BMG to communicate through Dhcp Select Dhcp within the WAN Configuration setup screen Setting your BMG to communicate through a Static IP address Example DSL installation Installation Overview For Adsl and Cable NetworksPHONE1 & PHONE2 Web Interface Screen Descriptions System Status StatusPort Status Window Port StatusDNS Dhcpc StatusPPPoE Status Window Description PPPoE StatusDescription PPPoE ConfigurationDhcp Configuration Dhcp Server ConfigurationWAN IP WAN ConfigurationRemote Provisioning DescriptionDevice Mode Configuration Window Device Mode1 NTP NTPPort Forwarding Napt ConfigurationIP Filtering IP Filter Configuration Window3 DMZ DMZ Configuration WindowQoS QoS ConfigurationDscp Configuration VLan Configuration Mac Cloning Window Mac CloningSwitch Key Pstn ConfigurationLength Digit MapGroup Provision ConfigurationSyslog Configuration Window Syslog Configuration11.1 EMS EMS ConfigurationSnmp Community Snmp Community Configuration WindowSnmp Trap Target Snmp Trap Configuration WindowProtocol VoIP ConfigurationUser DescriptionRstp Mgcp12.4 SIP VoIP SIP Configuration WindowSIP Domain 12.5 H.323 Specifies the password for secured registrationDtmf Codec DescriptionBMG7011 and BMG7012 User’s Guide Rev VoIP Caller ID Configuration Window RTP port 12.8 RTPBusy Tone ToneCall Waiting Tone 12.10 FAX VoIP Fax Configuration WindowNAT Address StunAdd/Modify Speed DialPort Configure port 1 or port 2 For BMG7012 Only Call Hold Call FeaturesPhone book Supervisor Password Password ConfigurationUser Password Window User PasswordFirmware Upgrade ConfigurationConfiguration Upgrade Window ConfigurationSave Save ConfigurationLoad Default Settings Window Load Default SettingsReboot Window RebootAppendix a Troubleshooting Appendix B Specifications