Oki BMG7012, BMG7011 manual Description, Codec

Page 51

BMG7011 and BMG7012 User’s Guide Rev. 1.9

3.12.6CODEC

This screen allows you to set CODEC configurations including Codec Rate, Preferred Codec, and VAD. Save and

Reboot.

 

Figure 33 – VoIP Codec Configuration Window

 

 

Item

Description

 

 

CODEC Rate

“CODEC rate” specifies the packetization time (in milliseconds).

 

The value is from 10 to 40 ms for G.711 in 10 ms increments (20ms recommended)

 

The value is from 10 to 80 ms for G.729A in 10 ms increments (20ms recommended)

 

The value is 30, 60 or 90 ms for G.723.1 (30ms recommended)

Preferred CODEC

Specifies the preferred method of voice compression.

VAD

Voice Activity Detection feature.

 

Enabled: sending packets only while the user is speaking. This will save the bandwidth but cause

 

the time delay.

© Copyright, 2004 Oki Network Technologies. All Rights Reserved

46

Image 51
Contents Broadband Media Gateway Document Revision History Copyrights Notice Contents 11.1 Package Contents FeaturesSystem Requirements Integrated Routing Features Front View LEDs Hardware InstallationLine Rear View PortsConfiguring TCP/IP Protocol for Your PC Initial Installation Procedures for Adsl and Cable NetworksConfiguring via Web Browser Configuring the BMG7011 and BMG7012 VoIP gatewaysSetting your BMG to communicate through PPPoE Supervisor ModeBMG7011 and BMG7012 User’s Guide Rev Setting your BMG to communicate through Dhcp Select Dhcp within the WAN Configuration setup screen Setting your BMG to communicate through a Static IP address Example DSL installation Installation Overview For Adsl and Cable NetworksPHONE1 & PHONE2 Web Interface Screen Descriptions System Status StatusPort Status Window Port StatusDNS Dhcpc StatusPPPoE Status Window Description PPPoE StatusDescription PPPoE ConfigurationDhcp Configuration Dhcp Server ConfigurationWAN IP WAN ConfigurationRemote Provisioning DescriptionDevice Mode Configuration Window Device Mode1 NTP NTPPort Forwarding Napt ConfigurationIP Filtering IP Filter Configuration Window3 DMZ DMZ Configuration WindowQoS QoS ConfigurationDscp Configuration VLan Configuration Mac Cloning Window Mac CloningSwitch Key Pstn ConfigurationLength Digit MapGroup Provision ConfigurationSyslog Configuration Window Syslog Configuration11.1 EMS EMS ConfigurationSnmp Community Snmp Community Configuration WindowSnmp Trap Target Snmp Trap Configuration WindowProtocol VoIP ConfigurationUser DescriptionRstp Mgcp12.4 SIP VoIP SIP Configuration WindowSIP Domain 12.5 H.323 Specifies the password for secured registrationDtmf Codec DescriptionBMG7011 and BMG7012 User’s Guide Rev VoIP Caller ID Configuration Window RTP port 12.8 RTPBusy Tone ToneCall Waiting Tone 12.10 FAX VoIP Fax Configuration WindowNAT Address StunAdd/Modify Speed DialPort Configure port 1 or port 2 For BMG7012 Only Call Hold Call FeaturesPhone book Supervisor Password Password ConfigurationUser Password Window User PasswordFirmware Upgrade ConfigurationConfiguration Upgrade Window ConfigurationSave Save ConfigurationLoad Default Settings Window Load Default SettingsReboot Window RebootAppendix a Troubleshooting Appendix B Specifications