Emerson manual Removing the AMC Module, AMC-S402 Installation

AMC-S402 Installation

5.Taking care to keep the module aligned in the guides, apply equal and steady pressure and slide the module in until the fingers of the module snap into the internal AMC connector.

DO NOT FORCE THE BOARD INTO THE SLOT.

6.Push the Module Handle to the IN position.

7.Power on the system, if necessary. Refer to your system manual for instructions on correctly powering on the system. Once power is applied to the chassis, the internal MMC controller runs a self-test that runs for approximately 10 seconds. Upon a successful power up self-test, the blue hot swap LED will blink and then turn off, indicating that the module has been placed in operation.

2.8Removing the AMC Module

!

Caution

The AMC-S402 AMC is hot-swappable and can be removed from the chassis without powering down the associated host carrier or chassis. This section describes the recommended procedure for removing an AMC module.

Before you remove your module, please read all cautions, warnings, and instructions presented in this section. Hot swap compliant modules may be removed while the system is powered on. If the chassis is not hot swap compliant, you should remove power to the slot or system before removing the module.

To remove the AMC module, follow these steps:

1.Begin to remove your module by pulling the module handle to the half way (HW) position. Do not remove the module immediately.

2.Powering down or removing a board before the operating system or other software running on the board has been properly shut down may cause corruption of data or file systems.

3.If your module is hot swap compliant and you are running fully functional hot swap-aware software, unlatching this ejector lever will start the shutdown process on the board. The software will slowly blink the blue hot swap LED indicating the module is in the process of being de-activated.

4.Once the module has been de-activated, the blue LED will solidly illuminate. Once this is done, you can extract the module by pulling on the module handle.

5.If your board or system is not running hot swap-aware software, the blue LED may illuminate without regard to software processes still running on the board. Be sure to manually shut down applications or operating systems running on the board prior to board removal.

6.Carefully pull the module from the chassis. If the card slot is to remain empty, install a filler panel in the slot.

6806800H60A AMC-S402 Installation and Use 8