Emerson 5150 Snmp Internet-standard Protocol Connectivity Module, Problem Cause Solution

A-6 SNMP Internet-standard Protocol Connectivity Module

Recommended ASCO SNMP MIB file

A file containing 934904-xxx.mib can be downloaded from the location shown below.

http://www.emersonnetworkpower.com/ en-US/Products/PowerSwitchingandControls/MonitoringandControl/Pages/ ASCO5150ConnectivityModuleAcc72E.aspx

The 934904-xxx.mib file is written in the MIB module definition language based on the SMI specifications. This protocol file contains a structure block of information pertaining to ATS status and analog data. When SNMP is enabled, the CM polls for the information and shares it with requesting SNMP manager(s). The SNMP manager must use the file as a reference in sending SNMP requests for ATS information.

Troubleshooting SNMP Configuration

Problem		Cause	Solution
SNMP Manager cannot communicate	-	Host running SNMP Manager is	- Check SNMP configuration at
with the Connectivity Module; do not		not in the same network or	Connectivity Module
get trap message after alarms occur.		Connectivity Module	configuration page.
	- SNMP is not enabled.		- Hook up a laptop to the same
			network and ping the
	- Incorrect SNMP IP Manager IP		Connectivity Module and SNMP
		addresses	Manager(s).
	-	Incorrect SNMP community
		setting.