Emerson CATALOG 5150 installation manual Select All Programs Accessories Command Prompt

Page 26

A-2 Ethernet TCP/IP Network Connections in Windows XP & 7

Connectivity Module

6.If the computer is on the company network contact the facilities IT personnel for appropriate settings.

If it is a stand-alone computer, enter the IP # for this computer that is listed on the Interface Diagram. For example:

IP address:	169.254.1.2 (last digit must
	be different than the CM)
Subnet Mask:	255.255.0.0 (same as CM)
Gateway:	0.0.0.0 (same as CM)
Windows XP

7.Once the TCP/IP setup is complete at the computer, restart the computer (click the Start button, then click Shut Down).

8.Restart Windows, then click the Start button.

Windows XP

Select All Programs > Accessories > Command Prompt.

Windows 7

In the Command Prompt window: type cmd and press ENTER.

9.In the command prompt window type ipconfig and press ENTER. The settings are displayed.

10.In the command prompt window type ping 169.254.1.1 and press ENTER. You should see:

Reply from 169.254.1.1

This reply confirms communication between the computer and the CM. Close the command prompt window. Proceed to the appropriate section How to View & Change Configuration Pages from a Connectivity Module.

Windows 7

Image 26

Contents Connectivity Module 381333-367 BPrerequisites Who Should Use this Installation ManualIi Welcome Connectivity Module Important informationCheck the DIP Switch Settings for RS485 SpecificationsInstallation Overview DIP Switch on bottom of unitIv Outline and Mounting Drawing Connectivity Module Wiring Diagrams Connectivity Module Connectivity Module Wiring Diagrams Vii Wiring Diagrams Connectivity Module Connectivity Module Wiring Diagrams Connectivity Module Status LEDs LED Description LED Function / Mode of OperationStatus LEDs Installation How to Install the Connectivity Module on Asco 940/962 ATSsConnectivity Module Installation How to Test Communication to the Connectivity ModuleHttp//169.254.1.1/config.htm Installation Connectivity ModuleConnectivity Module server Configuration left side Device Configurator Screen for 7000 & 4000 Series ATSsGroup 5 Controller Configuration right side Device Configurator Screen for 7000 & 4000 Series ATSs7000 & 4000 Series ATSs Connectivity Module Power Manager or Power Meter ConfigurationInput Name & Output Names Power Manager only Detail Screen for 7000 & 4000 Series ATSs Device Configurator Screen for Series 300 ATSs Device Configurator Screen for Series 300 ATSsGroup 1 Controller Configuration right side Series 300 ATSs Connectivity ModuleConnectity Module Series 300 ATSs Detail Screen for Series 300 ATSs with a Power Manager Detail Screen for Series 300 ATSsDevice Configurator Screen without Power Manager Device Configurator Screen for Asco 940/962 ATSsGroup 7A Controller Configuration right side Device Configurator Screen with Power ManagerAsco 940/962 ATSs Connectivity Module Detail Screen for Asco 940/962 ATSs with a Power ManagerDetail Screen for Asco 940/962 ATSs Power Manager or Power Meter Configuration Detail Screen for Power Managers connected to a Load Detail Screen for Digital Power Meters connected to a LoadDetail Screen for Power Managers connected to a Generator Detail Screen for PowerDetail On Local Area Connection Properties screen Select All Programs Accessories Command Prompt Connectivity Module Troubleshooting A-3 Problem CauseThird Party Modbus Device Configuration Read RequestsConnectivity Module Snmp Internet-standard Protocol A-5 Snmp Trap messagesProblem Cause Solution Snmp Internet-standard Protocol Connectivity ModuleCatalog No Address set ATS Controller PM or DPM Row IP Address Subnet Mask GatewaySerial No Index