Philips CPWBS001 manual Attach to Your Network Using Ethernet Cabling

Page 13

ENGLISH 13

Attach to Your Network Using Ethernet Cabling

The four Local Network ports 1, 2, 3 and 4 on the Wireless Base Station auto-negotiate the connection speed to 10 Mbps Ethernet or 100 Mbps Fast Ethernet, and the transmission mode to half duplex or full duplex.

Use twisted-pair cable to connect any of the four Local Network ports 1, 2, 3, and 4 on the Wireless Base Station to an Ethernet adapter on your PC. Otherwise, you can cascade any of the Local Network ports 1, 2, 3, and 4 on the Wireless Base Station to an Ethernet hub or switch, and then connect your PC or other network equipment to the hub or switch. When inserting an RJ-45 plug, be sure the tab on the plug clicks into position to ensure that it is properly seated.

Warning:Do not plug a phone jack connector into any RJ-45 port.This may damage the Wireless Base Station. Instead, use only twisted-pair cables with RJ-45 connectors that conform with FCC standards.

Image 13
Contents Wireless Base Station ➊ ➋ Helpline Table of Contents Power Reset buttonIndicator LEDs Technology for peoplePackaging contents Safety PrecautionsImportant information Environmental informationDisclaimer Station until the Setup Wizard asks you to do so Do not make any hardware connections to the Wireless BaseStart installing the software You make any hardware connectionsHow to use the Setup programme Hardware description Connect the System System RequirementsConnecting the Wireless Base Station Basic Installation ProcedureAttach to Your Network Using Ethernet Cabling Attach to Your Network Using Radio Signals Modem / Internet port on the Wireless Base Station Attach the Wireless Base Station to the InternetEnds for all connections Connecting the Power Adapter Setting Up TCP/IP Installing TCP/IPWindows Configuring Your Computer in Windows 98SE/Me Obtain IP Settings from Your Wireless Base Station Dhcp IP ConfigurationConfiguring Your Computer in Windows Dhcp IP Configuration Configuring Your Computer in Windows XPConfiguring a Macintosh Computer Manual IP Configuration for all Windows OS Ping Verifying Your TCP/IP ConnectionDisable Proxy Connection Browser ConfigurationInternet Explorer 5 or above Internet Explorer for Macintosh Making Configuration Changes Setup, virtual DMZ hosts, and other advanced functionsNavigating the Web Browser Interface DSL modemTime Zone Setup WizardBroadband Type Cable ModemPPPoE xDSL Fixed-IP xDSLPptp Point-to-Point Tunneling Protocol Click Finish to complete the setupMenu Description System Password SettingsDefault 9 minutes Factory defaults. The default is no passwordRemote Management Base StationDynamic IP Internet SettingsPoint-to-Point Over Ethernet PPPoE Point-to-Point Tunneling Protocol Pptp Static IP DNS Local netwerk LAN Channel and Ssid WirelessAvailable options are 1, 2, 5.5, and 11Mbps. Default All Default Fully AutomaticCommunicates with PCs in its service range. Default Auto Available channel settings are limited by local regulationsEncryption Address Mapping Network Address Translation NATVirtual Server 6112 Special ApplicationsBattle.net 28800Firewall Access ControlMAC Filtering Table As shown in the following screenParental Control Schedule Rule Use this section to create your network schedule rules Enables Schedule-based Internet access controlIntrusion Detection Firewall ConfigurationDMZ Demilitarized Zone Ddns Dynamic DNS Settings UPnP Universal Plug and Play Setting Tools Tools Configuration ToolsTools Firmware Upgrade Complete when the power LED stops blinking Tools RebootStatus Following items are included on this screenSection Description Displays Internet connection type and statusAm getting an IP Address that starts with Troubleshooting10/100 LED does not light after a connection is made Have another IP Address displayedLED Indicators Media Access ControlRF Specification StandardsRF Power Consumption RF Output PowerRF Frequency Operating ChannelEnglish 0682