Philips CPWBS001 manual Have another IP Address displayed

Page 60

60ENGLISH

C. I have another IP Address displayed

If you have another IP address listed then the PC may not be configured for a DHCP connection. Please refer to “Configuring Client TCP/IP” for information.

Once you have confirmed your computer is configured for DHCP, then please follow the steps below.

1.Open a DOS window as described above.

2.Type ipconfig/release.

3.Then type ipconfig/renew.

D. The 10/100 LED does not light after a connection is made.

1.Check that the host computer and the Wireless Base Station are both powered on.

2.Be sure the network cable is connected to both devices.

3.Verify that Category 5 cable is used if you are operating at 100 Mbps.

4.Verify that the length of any cable does not exceed 100 m (328 ft).

5.Check the network card connections.

6.The RJ-45 port on the Wireless Base Station, network card, or cable may be defective.

Image 60
Contents Wireless Base Station ➊ ➋ Helpline Table of Contents Reset button PowerIndicator LEDs Technology for peopleSafety Precautions Packaging contentsImportant information Environmental informationDisclaimer Do not make any hardware connections to the Wireless Base Station until the Setup Wizard asks you to do soStart installing the software You make any hardware connectionsHow to use the Setup programme Hardware description System Requirements Connect the SystemBasic Installation Procedure Connecting the Wireless Base StationAttach to Your Network Using Ethernet Cabling Attach to Your Network Using Radio Signals Attach the Wireless Base Station to the Internet Modem / Internet port on the Wireless Base StationEnds for all connections Connecting the Power Adapter Installing TCP/IP Setting Up TCP/IPWindows Configuring Your Computer in Windows 98SE/Me Dhcp IP Configuration Obtain IP Settings from Your Wireless Base StationConfiguring Your Computer in Windows Configuring Your Computer in Windows XP Dhcp IP ConfigurationConfiguring a Macintosh Computer Manual IP Configuration for all Windows OS Verifying Your TCP/IP Connection PingBrowser Configuration Disable Proxy ConnectionInternet Explorer 5 or above Internet Explorer for Macintosh Setup, virtual DMZ hosts, and other advanced functions Making Configuration ChangesNavigating the Web Browser Interface DSL modemSetup Wizard Time ZoneBroadband Type Cable ModemFixed-IP xDSL PPPoE xDSLClick Finish to complete the setup Pptp Point-to-Point Tunneling ProtocolMenu Description Password Settings SystemFactory defaults. The default is no password Default 9 minutesRemote Management Base StationInternet Settings Dynamic IPPoint-to-Point Over Ethernet PPPoE Point-to-Point Tunneling Protocol Pptp Static IP DNS Local netwerk LAN Wireless Channel and SsidDefault Fully Automatic Available options are 1, 2, 5.5, and 11Mbps. Default AllCommunicates with PCs in its service range. Default Auto Available channel settings are limited by local regulationsEncryption Network Address Translation NAT Address MappingVirtual Server Special Applications 6112Battle.net 28800Access Control FirewallAs shown in the following screen MAC Filtering TableParental Control Schedule Rule Enables Schedule-based Internet access control Use this section to create your network schedule rulesFirewall Configuration Intrusion DetectionDMZ Demilitarized Zone Ddns Dynamic DNS Settings UPnP Universal Plug and Play Setting Tools Configuration Tools ToolsTools Firmware Upgrade Tools Reboot Complete when the power LED stops blinkingFollowing items are included on this screen StatusSection Description Displays Internet connection type and statusTroubleshooting Am getting an IP Address that starts withHave another IP Address displayed 10/100 LED does not light after a connection is madeMedia Access Control LED IndicatorsRF Specification StandardsRF Output Power RF Power ConsumptionRF Frequency Operating ChannelEnglish 0682