Philips CPWBS001 manual Configuring a Macintosh Computer

Page 22

22ENGLISH

Configuring a Macintosh Computer

DHCP IP Configuration

You may find that the instructions here do not exactly match your screen.

This is because these steps and screenshots were created using Mac 9.0- or

Higher

1.Pull down the Apple Menu. Click Control Panel and select TCP/IP.

2.In the TCP/IP dialog box, make sure that Ethernet is selected in the Connect via: field.

3.Select Using DHCP Server in the Configure field.

4.Close the TCP/IP dialog box.

Image 22

Contents Wireless Base Station ➊ ➋ Helpline Table of Contents Indicator LEDs Reset buttonPower Technology for peopleImportant information Safety PrecautionsPackaging contents Environmental informationDisclaimer Start installing the software Do not make any hardware connections to the Wireless BaseStation until the Setup Wizard asks you to do so You make any hardware connectionsHow to use the Setup programme Hardware description System Requirements Connect the SystemBasic Installation Procedure Connecting the Wireless Base StationAttach to Your Network Using Ethernet Cabling Attach to Your Network Using Radio Signals Modem / Internet port on the Wireless Base Station Attach the Wireless Base Station to the InternetEnds for all connections Connecting the Power Adapter Setting Up TCP/IP Installing TCP/IPWindows Configuring Your Computer in Windows 98SE/Me Dhcp IP Configuration Obtain IP Settings from Your Wireless Base StationConfiguring Your Computer in Windows Configuring Your Computer in Windows XP Dhcp IP ConfigurationConfiguring a Macintosh Computer Manual IP Configuration for all Windows OS Verifying Your TCP/IP Connection PingDisable Proxy Connection Browser ConfigurationInternet Explorer 5 or above Internet Explorer for Macintosh Navigating the Web Browser Interface Setup, virtual DMZ hosts, and other advanced functionsMaking Configuration Changes DSL modemBroadband Type Setup WizardTime Zone Cable ModemFixed-IP xDSL PPPoE xDSLClick Finish to complete the setup Pptp Point-to-Point Tunneling ProtocolMenu Description Password Settings SystemRemote Management Factory defaults. The default is no passwordDefault 9 minutes Base StationInternet Settings Dynamic IPPoint-to-Point Over Ethernet PPPoE Point-to-Point Tunneling Protocol Pptp Static IP DNS Local netwerk LAN Wireless Channel and SsidCommunicates with PCs in its service range. Default Auto Default Fully AutomaticAvailable options are 1, 2, 5.5, and 11Mbps. Default All Available channel settings are limited by local regulationsEncryption Network Address Translation NAT Address MappingVirtual Server Battle.net Special Applications6112 28800Access Control FirewallAs shown in the following screen MAC Filtering TableParental Control Schedule Rule Enables Schedule-based Internet access control Use this section to create your network schedule rulesFirewall Configuration Intrusion DetectionDMZ Demilitarized Zone Ddns Dynamic DNS Settings UPnP Universal Plug and Play Setting Tools Configuration Tools ToolsTools Firmware Upgrade Tools Reboot Complete when the power LED stops blinkingSection Description Following items are included on this screenStatus Displays Internet connection type and statusTroubleshooting Am getting an IP Address that starts withHave another IP Address displayed 10/100 LED does not light after a connection is madeRF Specification Media Access ControlLED Indicators StandardsRF Frequency RF Output PowerRF Power Consumption Operating ChannelEnglish 0682