Philips CPWBS001 Factory defaults. The default is no password, Default 9 minutes, Base Station

Page 33

	ENGLISH 33
Note:	If your password is lost, or you cannot gain access to the user interface,
	press the Reset button (holding it down for at least five seconds) to restore
	the factory defaults. (The default is no password.)
	Enter a maximum Idle Time Out (in minutes) to define a maximum period
	of time for which the login session is maintained during inactivity. If the
	connection is inactive for longer than the maximum idle time, it will perform
	system logout, and you have to login to the web management system again.
	(Default: 9 minutes)
	Remote Management

	Remote Management allows a remote PC to configure, manage, and
	monitor the Wireless Base Station using a standard web browser. Check
	Enable and enter the IP address of the remote host. Click APPLY.
Note:	If you specify 0.0.0.0 as this IP address, any host can manage the Wireless
	Base Station.

Image 33

Contents Wireless Base Station ➊ ➋ Helpline Table of Contents Power Reset buttonIndicator LEDs Technology for peoplePackaging contents Safety PrecautionsImportant information Environmental informationDisclaimer Station until the Setup Wizard asks you to do so Do not make any hardware connections to the Wireless BaseStart installing the software You make any hardware connectionsHow to use the Setup programme Hardware description Connect the System System RequirementsConnecting the Wireless Base Station Basic Installation ProcedureAttach to Your Network Using Ethernet Cabling Attach to Your Network Using Radio Signals Attach the Wireless Base Station to the Internet Modem / Internet port on the Wireless Base StationEnds for all connections Connecting the Power Adapter Installing TCP/IP Setting Up TCP/IPWindows Configuring Your Computer in Windows 98SE/Me Obtain IP Settings from Your Wireless Base Station Dhcp IP ConfigurationConfiguring Your Computer in Windows Dhcp IP Configuration Configuring Your Computer in Windows XPConfiguring a Macintosh Computer Manual IP Configuration for all Windows OS Ping Verifying Your TCP/IP ConnectionBrowser Configuration Disable Proxy ConnectionInternet Explorer 5 or above Internet Explorer for Macintosh Making Configuration Changes Setup, virtual DMZ hosts, and other advanced functionsNavigating the Web Browser Interface DSL modemTime Zone Setup WizardBroadband Type Cable ModemPPPoE xDSL Fixed-IP xDSLPptp Point-to-Point Tunneling Protocol Click Finish to complete the setupMenu Description System Password SettingsDefault 9 minutes Factory defaults. The default is no passwordRemote Management Base StationDynamic IP Internet SettingsPoint-to-Point Over Ethernet PPPoE Point-to-Point Tunneling Protocol Pptp Static IP DNS Local netwerk LAN Channel and Ssid WirelessAvailable options are 1, 2, 5.5, and 11Mbps. Default All Default Fully AutomaticCommunicates with PCs in its service range. Default Auto Available channel settings are limited by local regulationsEncryption Address Mapping Network Address Translation NATVirtual Server 6112 Special ApplicationsBattle.net 28800Firewall Access ControlMAC Filtering Table As shown in the following screenParental Control Schedule Rule Use this section to create your network schedule rules Enables Schedule-based Internet access controlIntrusion Detection Firewall ConfigurationDMZ Demilitarized Zone Ddns Dynamic DNS Settings UPnP Universal Plug and Play Setting Tools Tools Configuration ToolsTools Firmware Upgrade Complete when the power LED stops blinking Tools RebootStatus Following items are included on this screenSection Description Displays Internet connection type and statusAm getting an IP Address that starts with Troubleshooting10/100 LED does not light after a connection is made Have another IP Address displayedLED Indicators Media Access ControlRF Specification StandardsRF Power Consumption RF Output PowerRF Frequency Operating ChannelEnglish 0682