Advanced port control, TP port 1 basic control

Black Box®LB1350A/LB1351A

TP port 1 basic control:

========================

1.Change Auto-Negotiation

2.Change 10M/100M

3.Change duplex mode

4.Disconnect port

5.Connect port

6.Reset device

0.Back to port control menu Select (0-6):

figure 6-7 – basic port control menu

Selecting any of these options will result in the appropriate action. The configuration changes require about a second to take effect. When you change the port’s setup, it will be restored the next time the device is powered on.

Please note that the port can only be disconnected when the VLAN mode is ‘enabled’. Note that for the FO port the only two options will be the duplex mode change and the device reset.

Advanced port control

The advanced port control menu, shown in figure 6-8, is composed of the following options:

•Set tag insertion mode (enable/disable)

•Set tag stripping mode (enable/disable)

•Set the port’s VLAN ID (0-4095)

•Set port based priority mode (enable/disable)

•Set 802.1p based priority mode (enable/disable)

•Set TOS based priority mode (enable/disable)

•Set the port’s user priority (0-7)

TP port 1 advanced control:

===========================

1.Enable/Disable tag insertion

2.Enable/Disable tag stripping

3.Set VLAN ID

4.Enable/Disable port priority

5.Enable/Disable 802.1p priority

6.Enable/Disable TOS priority

7.Set user priority

0.Back to port control menu Select (0-7):

figure 6-8 – advanced port control menu

If you wish to change the port’s VID or its user priority, you will be prompted for the desired values. Illegal values will not be accepted and will be rewarded with an ‘Invalid value!’ error message.

Setting any of the other options will cause the device to prompt the user for enabling (1) or disabling (0) the feature.

Please note that the VLAN related features (namely, tagging options) would take effect when the VLAN mode is ‘enabled’.

Detailed information regarding these options can be found in the advanced status section.