Chapter 9: OSD Computer
Alternatively, the EDID data of the connected display can be used. To do this, navigate to SAME AS DISPLAY EDID and press
ENTER/SELECT.
• SAME AS DISPLAY EDID: Write the contents of the display EDID to the current input EDID.
Press ENTER/SELECT to start the selected write option and wait until “successful” is displayed in the bottom status line. At this point, the EDID data can be written to one or all of the four channels.
NOTE: If the EDID data of the connected video source is used, the switch behaves as if the display is connected directly to the source.
NOTE: Keep in mind that this setting will overwrite the automatic analog input mode detection. If you connect a different video source, or change the video mode from the PC, you may need to change this setting again to get correct results. For the detection of digital input signals, this setting has no effect.
Alternatively, the display EDID data can be copied to the inputs:
Figure 9-10. Computer>EDID/DDC screen.
An overview of the contents of the display EDID is seen above.
It has the following write options:
WRITE TO INPUT 1 Write the monitor EDID to Input 1
WRITE TO INPUT 2 Write the monitor EDID to Input 2
WRITE TO INPUT 3 Write the monitor EDID to Input 3
WRITE TO INPUT 4 Write the monitor EDID to Input 4
WRITE TO ALL INPUTS Write the monitor EDID to all inputs
NOTE: The content of the input EDIDs can be reset to default by the OSD function CONFIGURATION/FACTORY RESET.
Page 70 |