Fujitsu BX600 SB9 manual Configure the Intel Adapter

Page 28

White Paper ⏐ Issue: October 2006 ⏐ Integration of BX600 SB9 Switches in Cisco NetworksPage 28 / 47

Step 3: Configure the Intel Adapter

To configure the Intel NIC, open the “Local Area Connection Properties” for the first adapter.

Press ”Configure”

Select the “Teaming” tab

Image 28

Contents Basic Multicast Services Contents Introduction Switch ConnectivitySwitch Management Page Introduction Configuration Recommended SolutionAuto Negotiation Network problems Port AggregationSet up the port-channel Shut down the affected ports to avoid loopsBring up the affected ports Verify the operation of the port-channelsVlan Trunk between SB9 and Cisco Switch VLANs and TrunksConfigure Vlan trunk Configure the port-channelsDefine the VLANs Verify the Vlan trunk GvrpSpanning Tree Protocol Running ST P 802.1D with PVST+ on Vlan TrunksSB9 Running PVST+ on Vlan Trunks while disabling STP at the SB9Combining RAPID-PVST and 802.1w Rapid Spanning TreeCombining RAPID-PVST and 802.1w after failure of Po1 SB9 Switch Configuration with Vlan TrunksConfigure the switches Network loopsPage Page Verify the configuration STPPage Configuration example Rstp without Vlan trunks Configuration without Vlan TrunksPage Mode Type State Role Enabled Forwarding Designated Disabled Enabled Disabled PC Mbr Manual forwarding Interface Access Port and NIC Configuration BX600 port mappingTypical access port configuration Configure the access ports of the switchesConfigure the Broadcom NIC Page Configure the Intel Adapter Page Select Switch Fault Tolerance and press Next Press Finish Configure a Link State Group Link StateRecommended solution ConfigurationEnable multicast routing and Igmp at the layer 3 switch Enable Igmp snooping at all Layer 2 switchesVlan Page Configuration of syslog and Sntp Configure the SB9 for unicast SntpConfigure the SB9 for broadcast Sntp Configure the SB9 for logging and syslogTest the configuration Configuration of Snmp Configure Snmp for SNMPv1 and SNMPv2cConfigure SNMPv3 authentication SnmpRemote Console Access Configuration of SSHConfigure the SB9 Test the loginIntegration into Radius and TACACS+ Configuration of RadiusPrepare the ACS Page Specify the user’s password and press Submit Test the login Configuration of Tacacs Page Configure the SB9 Check the configuration Configuration of CDPCisco Discovery Protocol Port Monitoring Configuration of Port MonitoringFurther information in the Internet