Fujitsu BX600 SB9 manual

White Paper ⏐ Issue: October 2006 ⏐ Integration of BX600 SB9 Switches in Cisco Networks

channel-group 1/1 exit port-channel Po2 interface 1/2 exit

interface 0/13 channel-group 1/2 exit

interface 0/14 channel-group 1/2 exit

!Configure the interfaces interface range 0/1 – 0/10 spanning-tree edgeport spanning-tree port mode interface range 0/11 – 0/14 spanning-tree port mode exit

interface 1/1 staticcapability spanning-tree port mode exit

interface 1/2 staticcapability spanning-tree port mode exit

end

!Cisco Switch A

!Enable and configure RSTP

spanning-tree mode rapid-pvst spanning-tree vlan 1 priority 0

!Timers are tuned. Please refer Cisco documentation before

!using this part of the configuration

!

spanning-tree vlan 1 hello-time 1 spanning-tree vlan 1 forward-time 8 spanning-tree vlan 1 max-age 11

!

!Define the port-channels

interface Port-channel1

!These commands are default and normally not displayed switchport mode access

switchport access vlan 1

!

interface Port-channel3

!These commands are default and normally not displayed switchport mode access

switchport access vlan 1

!

interface range GigabitEthernet0/1 - 2

!These commands are default and normally not displayed switchport mode access

switchport access vlan 1 channel-group 1 mode on

!

interface range GigabitEthernet0/23 - 24

!These commands are default and normally not displayed switchport mode access

switchport access vlan 1 channel-group 3 mode on

!Cisco Switch B

Page 21 / 47