Fujitsu BX600 SB9 manual

Page 44

White Paper ⏐ Issue: October 2006 ⏐ Integration of BX600 SB9 Switches in Cisco Networks

Page 44 / 47

Add the users to the ACS database, e.g. the user “test-ro”

Specify the user’s password and press “Submit”

Page 43 Page 45
Image 44
Page 43 Page 45
Contents Switch Management Contents Introduction Switch ConnectivityBasic Multicast Services Page Introduction Auto Negotiation Recommended SolutionConfiguration Network problems Port AggregationSet up the port-channel Shut down the affected ports to avoid loopsBring up the affected ports Verify the operation of the port-channelsVlan Trunk between SB9 and Cisco Switch VLANs and TrunksDefine the VLANs Configure the port-channelsConfigure Vlan trunk Verify the Vlan trunk GvrpSpanning Tree Protocol Running ST P 802.1D with PVST+ on Vlan TrunksSB9 Running PVST+ on Vlan Trunks while disabling STP at the SB9Combining RAPID-PVST and 802.1w Rapid Spanning TreeCombining RAPID-PVST and 802.1w after failure of Po1 SB9 Switch Configuration with Vlan TrunksConfigure the switches Network loopsPage Page Verify the configuration STPPage Configuration example Rstp without Vlan trunks Configuration without Vlan TrunksPage Mode Type State Role Enabled Forwarding Designated Disabled Enabled Disabled PC Mbr Manual forwarding Interface Access Port and NIC Configuration BX600 port mappingTypical access port configuration Configure the access ports of the switchesConfigure the Broadcom NIC Page Configure the Intel Adapter Page Select Switch Fault Tolerance and press Next Press Finish Configure a Link State Group Link StateRecommended solution ConfigurationEnable multicast routing and Igmp at the layer 3 switch Enable Igmp snooping at all Layer 2 switchesVlan Page Configuration of syslog and Sntp Configure the SB9 for unicast SntpConfigure the SB9 for broadcast Sntp Configure the SB9 for logging and syslogTest the configuration Configuration of Snmp Configure Snmp for SNMPv1 and SNMPv2cConfigure SNMPv3 authentication SnmpRemote Console Access Configuration of SSHConfigure the SB9 Test the loginPrepare the ACS Configuration of RadiusIntegration into Radius and TACACS+ Page Specify the user’s password and press Submit Test the login Configuration of Tacacs Page Configure the SB9 Cisco Discovery Protocol Configuration of CDPCheck the configuration Further information in the Internet Configuration of Port MonitoringPort Monitoring
Top Page Image Contents