Fujitsu BX600 SB9 manual Configure the Broadcom NIC

Page 26

White Paper Issue: October 2006 Integration of BX600 SB9 Switches in Cisco Networks

Page 26 / 47

switchport allowed vlan add 10

!Set the access VLAN as native VLAN switchport native vlan 10

exit

!This line is only needed if you are running STP on the switch spanning-tree edgeport

!Forbid all VLANs but the access VLAN

switchport forbidden vlan add 1 switchport forbidden vlan add 10

!Permit the access VLAN switchport allowed vlan add 20

!Set the access VLAN as native VLAN switchport native vlan 20

exit

Step 2: Configure the Broadcom NIC

To configure the Broadcom NIC, start the “Broadcom Advanced Control Suite 2”.

This is the main window of the “Broadcom

Advanced Control Suite 2”.

Select the menu item “Tools->Create a

Team”

Enter a name for the team and press “Next>”

Image 26
Contents Switch Management Contents Introduction Switch ConnectivityBasic Multicast Services Page Introduction Auto Negotiation Recommended SolutionConfiguration Network problems Port AggregationSet up the port-channel Shut down the affected ports to avoid loopsBring up the affected ports Verify the operation of the port-channelsVlan Trunk between SB9 and Cisco Switch VLANs and TrunksDefine the VLANs Configure the port-channelsConfigure Vlan trunk Verify the Vlan trunk GvrpSpanning Tree Protocol Running ST P 802.1D with PVST+ on Vlan TrunksSB9 Running PVST+ on Vlan Trunks while disabling STP at the SB9Combining RAPID-PVST and 802.1w Rapid Spanning TreeCombining RAPID-PVST and 802.1w after failure of Po1 Configure the switches SB9 SwitchConfiguration with Vlan Trunks Network loopsPage Page Verify the configuration STPPage Configuration example Rstp without Vlan trunks Configuration without Vlan TrunksPage Mode Type State Role Enabled Forwarding Designated Disabled Enabled Disabled PC Mbr Manual forwarding Interface Access Port and NIC Configuration BX600 port mappingTypical access port configuration Configure the access ports of the switchesConfigure the Broadcom NIC Page Configure the Intel Adapter Page Select Switch Fault Tolerance and press Next Press Finish Configure a Link State Group Link StateEnable multicast routing and Igmp at the layer 3 switch Recommended solutionConfiguration Enable Igmp snooping at all Layer 2 switchesVlan Page Configure the SB9 for broadcast Sntp Configuration of syslog and SntpConfigure the SB9 for unicast Sntp Configure the SB9 for logging and syslogTest the configuration Configure SNMPv3 authentication Configuration of SnmpConfigure Snmp for SNMPv1 and SNMPv2c SnmpConfigure the SB9 Remote Console AccessConfiguration of SSH Test the loginPrepare the ACS Configuration of RadiusIntegration into Radius and TACACS+ Page Specify the user’s password and press Submit Test the login Configuration of Tacacs Page Configure the SB9 Cisco Discovery Protocol Configuration of CDPCheck the configuration Further information in the Internet Configuration of Port MonitoringPort Monitoring