Port Monitoring | Fujitsu BX600 SB9 specification

White Paper ⏐ Issue: October 2006 ⏐ Integration of BX600 SB9 Switches in Cisco Networks

Page 47 / 47

0/11 Enable

0/12 Enable

0/13 Enable

0/14 Enable

0/15 Enable

0/16 Enable

4.6Port Monitoring

4.6.1 Introduction

When a network analyzer is used in a switched network, a special switch port configuration is needed in order to copy frames from a specified port to the analyzer port.

This feature is called the “port-monitor” at the SB9 or the “port-mirror” for Cisco switches. The SB9 supports one monitor session with multiple source interfaces, and one destination interface to which the network analyzer is connected. At present port-mirror is not supported on port-channel interfaces.

4.6.2 Configuration of Port Monitoring

The following steps are necessary in order to configure a port monitor session.

∙Step 1: Configure the SB9

∙Step 2: Check the configuration

Step 1: Configure the SB9

!Stop an existing monitor session if applicable no port-monitor session 1

!Start a new monitor session

port-monitor session 1 source interface 0/1 port-monitor session 1 destination interface 0/4 port-monitor session 1 mode both

Step 2: Check the configuration

(bx6-sb9-a) #show port-monitor session 1

Session ID	Admin Mode	Dest. Port	Source Port
1----------	----------	----------	-------------
1----------	Enable-Both	0/4	0/1

4.7Further information in the Internet:

PRIMERGY servers

www.fujitsu-siemens.com/primergy

Delivery subject to availability, specifications subject to change without notice, correction of errors and omissions excepted.

All conditions quoted (TCs) are recommended cost prices in EURO excl. VAT (unless stated otherwise in the text). All hardware and software names used are brand names and/or trademarks of their respective holders.

Published by:

FSC EP ESB ST PRIMERGY Enterprise Server Business, Support & Trainings

Extranet:

http://extranet.fujitsu-siemens.com/primergy Internet: http://www.fujitsu-siemens.com/primergy