Xerox M118i manual Enable the E-mail Ports, Enter the Smtp Settings, Configuring Scan to E-mail

Configuring Scan to E-mail

Enable the E-mail Ports

1.Click the Properties tab.

2.Select Port Status on the left sidebar.

a.Enable the SNMP, Send E-mail, and Mail Notice Service ports. Do not modify the other port settings on this page.

b.Click the Apply New Settings button at the bottom of the page.

c.At the reboot prompt, click the Reboot button.

3.Wait one minute for the reboot to complete, and then click the browser Refresh button.

Enter the SMTP Settings

1.Click the Properties tab.

2.Select the Protocol Settings folder on the left sidebar, and then select E-mail.

a.Enter the SMTP Server Address.

b.If SMTP authentication is required, enter the POP3 Server Address, POP User Name, and POP Password.

Note

The POP3 Server Address can be entered as an IP address or a server name.

c.If the machine uses a host name rather than an IP address, click TCP/IP in the left side bar, and verify that the DNS Address 1 field contains the DNS Server Address. For more information, see the Network Connection Quick Setup Guide.

d.Click the Apply New Settings button at the bottom of the page.

e.At the reboot prompt, click the Reboot button.

3.Wait one minute for the reboot to complete, and then click the browser Refresh button.

Create an Address Book Entry to Use for Verifying Scan to E-mail Setup

1.Click the Properties tab.

2.Select Address Book on the left sidebar.

a.Type a Speed Dial number from 1–200 to assign to the test recipient, and then click the Edit button.

b.Select E-mailfrom the Address Type drop-down list.

c.Enter the recipient’s local E-mail address in the Recipient Address field.

d.Enter the Recipient Name.

e.Click the Apply New Settings button.

Xerox WorkCentre M118i

4