Xerox 721P85600 manual Dry ink toner, Fuser agent, Developer, Tapes

Page 58

PREINSTALLATION

Dry ink (toner)

Dry ink (also referred to as “toner”) is the black powder which forms the image on the printed page. There are three cartridges of dry ink in each container. Keep an adequate supply on hand at all times. The operator can change throw-away cartridges easily with no mess. Use only dry ink that is specified for use in your LPS. (Refer to the consumable supplies table at the end of the “Postinstallation” chapter.)

Fuser agent

Fuser agent is a consumable item required by the LPS. Keep an adequate supply on hand for installation by the Xerox or Xerox Limited service representative.

Developer

Developer is a required item that needs to be ordered and kept on hand. It is changed by a Xerox or Xerox Limited service representative. Use only developer specified for use in your LPS. (Refer to the consumable supplies table at the end of the “Postinstallation” chapter.)

Tapes

Each of the tape drives available on the DocuPrint 96/DocuPrint 96MX LPS requires a different tape format.

1/4-inch (QIC) The 1/4-inch QIC tape drive uses quarter-inch stream cartridge tapes. The tape data capacity should be 320 MB with 225 KB/second data transfer rate.

36-TRACKThe optional 18/36-track tape drive uses 0.5 inch cartridge tapes with a data capacity of 1.2 GB.

18-TRACKThe optional 18/36-track tape drive also uses 0.5-inch IBM 3480- compatible cartridge tapes with a data capacity of 200 MB. Cartridges are not available from Xerox.

9-TRACKThe optional 9-track tape drive supports reel-to-reel 9-track 1600 bpi (PE) and 6250 bpi (GCR) encoded magnetic tapes.

3-28

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS INSTALLATION PLANNING GUIDE

Image 58
Contents April 1998 721P85600 Page Related publications Related Publications NumberPage Table of Contents Installation Glossary PostinstallationIndex Viii Introduction What this guide containsIntroduction Xerox DocuPrint 96/DocuPrint 96MX LPS PDL Reference Xerox DocuPrint 96/DocuPrint 96MXLPS Operator Guide LPS Operations ReferenceLPS Message Guide Xerox DocuPrint 96/DocuPrint 96MX LPS Forms Creation GuideCard User GuideResponsibilities Xerox or Xerox Limited responsibilitiesCustomer responsibilities Installation planning checklist Installation planning checklist Week Activity Reference Responsibility Date completedXvii Xviii LPS overview Xerox DocuPrint 96/DocuPrint 96MX LPSBase components System controller componentsSystem user interface keyboard display Keyboard displayXerox DocuPrint 96/DocuPrint 96MX printer components LPS Overview Magnetic Ink Character Recognition Micr Micr lineOnline interface System controller optionsInterface options Offline interfacesHIP-accessed interfaces Enhanced graphics ink and font memory Egifm Expanded system disk memoryFloppy disk drive Feeder stacker Printer optionsBypass transport Printer Configurations Input enablement deviceHost Resident software packages Printer + Inverter Feeder Stacker + Feeder StackerPreinstallation LPS delivery requirementsSystem controller Preinstallation Printer Printer with an inverter feeder/stacker and a feeder/stacker Preinstallation Clearance space requirements Space planning guidelinesShared space Back-to-back shared service area space Face-to-face shared service area space Power cable and data cable length Cable lengthsCable locations 10.Cable enter/exit locations top viewDelivery access requirements Efficiency of usePreinstallation Turning radius for inverter Feeder/Stacker module Turning radius for printer separated and upendedOn dolly Passage or doorway a width Minimum passage B width Passage or doorway a width Minimum passage B widthPreinstallation Environmental/electrical requirements Delta Printer power receptacle requirements Electrical environment Voltage/current ReceptacleHz WYE printer outlet voltages Service outlet Configuration Measurement Nominal Range10. Printer 50 Hz only WYE connection for 380 V Hz Delta printer outlet voltages Hz printer outlet voltages RMSHz system power cord configurations 12.Printer power cord 60 Hz installation for 50 amp NemaChannel-attached Interface requirementsFinishing and feeding equipment Third party connectionsOperator training TrainingSystem training Preinstallation Ordering supplies for installation FontsPaper Developer Dry ink tonerFuser agent TapesSpace planning templates 14.Space planning templates top views 15.Space planning templates top views Page Grid Pattern 1/4 inch represents one foot Page Installation Installation processInstallation responsibilities Documentation Documentation and software kitsSoftware kits Page Postinstallation Xerox support servicesXerox Customer Support Center Customer Service Support Center Xerox Customer Documentation Catalog Xerox Font CenterFont U.S. only Xerox Documentation and Software Services Xdss Xerox Supplies Order Service Routine maintenance Meter reading and reportingIdentifying new applications Types of applications availableConsumable supplies table Consumable supplies, paper Description Part number PaperHigh Speed Labels Consumable supplies, paper Description Part numberTransparencies GummedDescription Part number Tab stock Cleaning suppliesConsumable supplies, paper Cover stockStock Reverse Alternating 5000 2500 3R4228 Supplies checklist Glossary Glossary Glossary Glossary Glossary Glossary Glossary Glossary Glossary Glossary GLOSSARY-11 Glossary GLOSSARY-13 Glossary GLOSSARY-15 Glossary GLOSSARY-17 Glossary GLOSSARY-19 Glossary GLOSSARY-21 Glossary GLOSSARY-23 Glossary GLOSSARY-25 Ips HposLaser Lpi PpmGlossary GLOSSARY-29 Page QGH Page Page 522&835,172&835,170/36,167$//$7,213/$11,1**8