PRINTERS
Figure 3-2. High capacity stackers
Each HCS can hold 2500 sheets of 20 pound or 80 gsm paper stacked on the bin platform.
Note: For large paper sizes such as 11 x 17 inches or A3, there is a stack limit of about 1500 sheets. This limit is needed to keep the total weight of the stack within safe limits for unloading and lifting.
A stacking elevator maintains the paper at the proper level for stacking and lowers the stack for unloading. There is an offset mechanism that offsets printed sets toward the front or back of the HCS bin. Each HCS bin has unlinked double doors to provide you with easy, yet safe, access for unloading paper from the printer.
Purge tray The purge tray is located on top of the feeder/stacker module. Aborted sheets (for example, damaged sheets or sheets cleared after a paper jam) are sent to this tray. The purge tray can hold up to 100 sheets of paper.
Attention light An attention light is mounted on top of the inverter module. The attention light signals when the printer requires operator attention:
•
•
Off. No printer problems exist that require your attention.
Steady light. A situation exists that needs your attention (such as low dry ink condition).
•Flashing. The printer has stopped and requires your attention immediately.
Note: When the attention light starts flashing, an explanatory message appears on the printer control console display. A similar message appears on the printer controller screen.
Sample button The Sample button on the 180, 4635, or 96 printer will duplicate one of the sheets in the paper path and deliver it to the sample tray. This sheet can be used to check quality and alignment while printing. The button is disabled for MICR enabled printers.
Sample tray The sample tray located on top of the printer holds up to 100 sheets of paper. It receives output such as transparencies, sample prints or system files, and waste sheets that cannot be sent to the purge tray.
XEROX DOCUPRINT 96/4635/180 NPS SYSTEM OVERVIEW GUIDE |