Xerox 96, 4635, 180 manual Table B-4.Paper stocks guide, Stock type Instructions for use

PAPER PERFORMANCE GUIDELINES

		Table B-4.Paper stocks guide
Stock type	Instructions for use
16 pound/60 gsm paper	•	Load paper with ream wrapper seam side down. If there is no arrow on the
		ream wrapper, load paper in trays 3, 4, 5 and 6 only, with curl up.
	• Duplexing 16 lb. paper is not recommended.
	• Best performance can be expected from trays 3, 4, 5 and 6.
20 pound/80 gsm paper	Load paper with ream wrapper seam down. If there is no arrow on the ream
	wrapper, load paper in trays 3 and 4 only, with curl up.
65 pound card stock	Run from any tray.
110 pound/200 gsm paper
(index)
20 pound or 80 gsm dual-	• Load with holes to the RIGHT.
purpose	• Use the Shift task to avoid printing near the holes.
3-hole drilled
	• Fan paper thoroughly and check for loose paper plugs prior to loading
4-hole drilled
7-hole drilled
Non-tearing 3-hole	• Load in trays 1 and 2 only.
	• Load with holes to the RIGHT.
	• DO NOT run two-sided (duplex) prints.
Non-tearing	• Load in trays 1 and 2 only.
	• DO NOT run two-sided (duplex) prints.
Xerox carbonless paper	• Load paper in trays 3, 4, 5 and 6 only.
	• Only Xerox carbonless paper is recommended for High speed Xerographic
		equipment.
3-hole drilled, edge	• Use trays 1 and 2.
reinforced dual-purpose	• Load paper with holes to the right, reinforced side DOWN.
	• In two-sided (duplex) printing, degraded print quality may occur near the
		reinforcement.
	• Leave stock in wrapper until use to achieve maximum stock flatness.
	• Run with no more than 200 sheets in a tray.1
Transparencies—	• Load with the white stripe to the RIGHT in trays 1 and 2 (“shiny” side UP for
Oversized (8.5 by 14 inches,		best performance).
0.5 inch white stripe/216 by 356	•	Simplex only.
mm, 1 mm white strip)
Preprinted stock	Certain types of ink or insufficient drying time may cause the ink to adhere to
	various machine components and printed sheets. Allow at least 3 hours of drying
	time before using preprinted stock.
	CAUTION: Certain preprinted stocks lie unevenly in the feeder trays. If the right
	side of the stack is higher than the left in trays 3, 4, 5 and 6 SEVERE hardware
	damage can occur. Load the stock in trays 1 or 2 or load fewer sheets.
Transparencies—	• High-speed paper-backed transparencies may be run from trays 1 and 2
Paper-backed,		with paper side DOWN.
high-speed,	• Run no more than 50 removable stripe transparencies at one time.
removable stripe
	• Load the transparencies on top of approximately 50 sheets of paper.

B-4 XEROX DOCUPRINT 96/4635/180 NPS SYSTEM OVERVIEW GUIDE