Xerox 701P21110 manual Preparing to print a tape job, Importing resource files

Page 28

Managing and printing jobs from the Tape Client

Saving a tape You can save a tape client setup including the following areas of client setup the Tape Client window:

•Input Device

•Output Control

•End of Job

•Document

To save a tape client setup:

•Click Save Setup in the Job Setup area to save the setup under its current name, or

•Click Save As... in the Job Setup area to save the setup under a new name.

To delete a tape client setup, click Delete.

Preparing to print a tape job

This section describes tasks that you perform to access the Tape

Client and set up a tape job for printing.

NOTE: The parameters that you specify on the Tape Client window override the settings of the queue to which the job is sent.

Importing resource files

In order to print a job from tape, the resources (forms, fonts, JDLs, JDEs, etc.) that are required by the job must be loaded in the “lcds” resources folder on the DP 2000 Series EPS system disk. If any of the resources that are needed for your job are missing from this folder, you must import them from the media on which they reside (diskette, tape, or another folder in the UNIX file system on the DP EPS controller). To import resource files to the “lcds” folder:

1.Click Administration on the DocuSP Print Services window.

2.Click the Lcds Resources tab to display the list of resources that are currently in the “lcds” folder.

2-4	Tape Client Job Submission Guide

Image 28

Contents Tape client USA Table of contents Managing and printing jobs from the Tape Client Managing the Tape ClientSafety Laser safetyOperation safety U. S Ozone information U. S. onlyOperation safety Europe Electrical supply Operator accessible areasVentilation Before cleaning your product MaintenanceCE mark Europe only Radio and telecommunications equipment directive Europe only For further information Safety Xii Tape Client Job Submission Guide Introduction ContentsAbout this guide Conventions Documentation DocuPrint 2000 Series 100/115/135/155/180 EPS documentationPrinting customer documentation Cd /usr/ucbFeatures and capabilities Tape Client overviewTape Client capabilities IBM DOS/360 Power II HOST=POWER Supported tape formatsStreaming and spooling transmission modes Functional overviewJob and tape status reporting Tape job accounting Tape dumpJob recovery Input processing from tape using Print Description Language Host computer tape formatsTape codes Record formatsOffline dump Record structureFormat Managing and printing jobs from the Tape Client Overview of the printing processTape Client window End of Job field on Tape Client window Preparing to print a tape job Importing resource filesLcds Resources window with Source menu displayed Lcds Resources window displaying resource files on tape Popup menu with Import selected Specifying files for printingSpecifying the JDL, JDE, and form to start a job Document field on Tape Client window Job Descriptor Library window Ending a job Controlling input for tape jobsMoving over files on a tape Move Tape Mark window Moving over blocks on a tape 10. Move Block windowStarting and ending tape dump sessions Setting up the printer for offline printing Accessing the Tape ClientManaging the Tape Client Printer setup window Adding a printerModifying a printer Deleting a printerManaging the tape drive Rename Device windowManaging the tape job accounting log Click Rewind or UnloadViewing the job log Printing the job log Click Print LogPage Managing the Tape Client Tape Client Job Submission Guide Index JDLINDEX-2