Xerox 8825/8830 manual Media Jams

Page 33

PROBLEM SOLVING

Media Jams

When a media jam occurs, the printer stops.

The Graphic Fault Display flashes an LED in the area where the fault has occurred. At the same time, a Status Code appears on the Message Display. The Message Display will also show the correct action to take in order to clear the jam:

1.Follow the instructions on the Message Display.

2.If the jammed media is visible, try to pull the media gently out of the printer and discard the media.

If the media cannot be removed easily, or if it tears and only part of the sheet is removed, continue with this procedure.

WARNING

Do not touch the fuser (red) roll inside the printer while performing the following steps. The fuser roll is very hot and can cause severe burns.

A

3.Lower the Cut Sheet Media Shelf (A).

4.Reach carefully into the printer and remove the jammed media.

5.If the media has been torn, remove all of the pieces.

6.After all of the jammed media has been removed, close the shelf/cover and go to step 8.

7.If the jammed media is not visible from the left side of the printer, close the shelf/cover and go to the right side of the printer.

XES Synergix 8825/8830 Printer Operator Manual

29

Image 33
Contents XES Synergix 8825/8830 Printer Operator Manual Class a EME Compliance in CanadaTrademark Acknowledgments Introduction For Service on Your PrinterTable of Contents Safety Notes Safety Notes Ground Fault Protection Printer Overview Controller On/Off Switch Printer On/Off SwitchGround Fault Protector Cutter DrawerToner Waste Container Front View front door openGraphic Display Numeric Keypad Cancel/Clear ButtonMessage Display Language Button Media Button Previous ButtonPower ON/OFF Switching On and OffPrinter is Warming UP Rest Mode Fuser is OFF Press Enter to Warm UP Printer Power Saver, Rest ModesLoading the Rolls of Media Media InformationMedia Information Media Information Media Information Media View Menu Media in Roll 1 is 36.0 Inch Bond Enter to ChangeSelect Media Width 36.0 Inch Select Media Type Bond Manual Bypass Feed Printer Menu OFF-LINE MenusAudible Indicators Printer Menu EntryPrinter Menu Printer Menu Audible Indicators Alarm = onKeypress = on Timers Printer Menu TimersPower Saver to Rest = xxx Minutes Printer Menu Printer Adjustments Printer AdjustmentsEnter NEW Value 0 Finisher Settings Printer Menu Finisher SettingsFinisher Config Type = None Finisher Config Type =Printer Menu Diagnostics DiagnosticsTest Plot Billing Meters Printer Menu Billing MetersProblem Solving Status CodesStatus Explanation Code Media Jams Error Messages Checking for Loss of Power Print Quality Problem What to DoBond Paper VellumReplacing the Toner Cartridge CareCare Remove the red cover tape Replacing the Toner Waste Bottle Required Tasks Calling for ServiceSupplies Order List Ordering SuppliesXES Synergix 8825/8830 Printer Printer DimensionsPower Consumption Electrical SpecificationsHeat Dissipation Environmental RequirementsPrints per Minute Bond Media Size Portrait Landscape XES Synergix 8825/8830 Printer Operator Manual USA USA