Xerox 8825/8830 manual Printer Menu Diagnostics, Test Plot

Page 30

OFF-LINE MENUS

Printer Menu - Diagnostics

DIAGNOSTICS

<TEST PLOT>

1.When DIAGNOSTICS is displayed on the Control Panel, press the Enter button to display the first feature.

2.Press the Enter button to select the <TEST PLOT> feature.

XES Synergix 8825/8830 Printer Operator Manual

26

TEST PLOT

PRINT FROM <ROLL x>

3.Press the Next (or Previous) button in order to scroll through the available settings (Roll 1, Roll 2 (Optional for the 8825), Roll 3 (Not available for the 8825), BYPASS (Optional for the 8825).

4.Press the Enter button in order to enter your selection, or

press Exit if no change is required.

5. Press the Exit button in order to return to the DIAGNOSTICS submenu.

NOTE: There are two other features in the submenu that are reserved for the Service Representative. The diagnostic feature is protected by a password.

Image 30
Contents XES Synergix 8825/8830 Printer Operator Manual EME Compliance in Canada Class aTrademark Acknowledgments For Service on Your Printer IntroductionTable of Contents Safety Notes Safety Notes Ground Fault Protection Printer Overview Ground Fault Protector Printer On/Off SwitchController On/Off Switch Cutter DrawerFront View front door open Toner Waste ContainerMessage Display Language Button Media Button Numeric Keypad Cancel/Clear ButtonGraphic Display Previous ButtonPower ON/OFF Switching On and OffPrinter is Warming UP Power Saver, Rest Modes Rest Mode Fuser is OFF Press Enter to Warm UP PrinterMedia Information Loading the Rolls of MediaMedia Information Media Information Media Information Media View Menu Media in Roll 1 is 36.0 Inch Bond Enter to ChangeSelect Media Width 36.0 Inch Select Media Type Bond Manual Bypass Feed OFF-LINE Menus Printer MenuAudible Indicators Printer Menu EntryPrinter Menu Printer Menu Audible Indicators Alarm = onKeypress = on Printer Menu Timers TimersPower Saver to Rest = xxx Minutes Printer Menu Printer Adjustments Printer AdjustmentsEnter NEW Value 0 Finisher Config Type = None Printer Menu Finisher SettingsFinisher Settings Finisher Config Type =Printer Menu Diagnostics DiagnosticsTest Plot Printer Menu Billing Meters Billing MetersProblem Solving Status CodesStatus Explanation Code Media Jams Error Messages Checking for Loss of Power Bond Paper Problem What to DoPrint Quality VellumCare Replacing the Toner CartridgeCare Remove the red cover tape Replacing the Toner Waste Bottle Calling for Service Required TasksOrdering Supplies Supplies Order ListPrinter Dimensions XES Synergix 8825/8830 PrinterHeat Dissipation Electrical SpecificationsPower Consumption Environmental RequirementsPrints per Minute Bond Media Size Portrait Landscape XES Synergix 8825/8830 Printer Operator Manual USA USA