Xerox 8825/8830 manual Safety Notes

Page 7

SAFETY NOTES (continued)

Slots and openings in the cabinet and in the back and bottom of the printer are provided for ventilation. To ensure reliable operation of the printer and to protect it from overheating, never position the printer so that these openings are near a radiator or heat register. The printer should not be placed in a built-in installation unless adequate ventilation is provided.

Never push objects of any kind into the slots of the printer in order to avoid touching dangerous voltage points or short out parts that could result in a risk of fire or electric shock.

Never spill liquid of any kind on the printer.

Never remove any covers or guards that require a tool for removal. There are no operator serviceable areas within these covers.

Never attempt any maintenance function that is not specified in this operator manual.

Never defeat the interlock switches. Your printer is designed to prevent operator access to unsafe areas. The covers, the guards, and the interlock switches are provided to ensure that the system will not operate when the covers are open.

Unplug the printer from the wall outlet and refer all servicing to qualified service personnel under the following conditions:

When the power cord is damaged or frayed.

If liquid has been spilled into the printer.

If the printer has been exposed to rain or water.

If the printer is producing unusual noises or odors. If the printer or the cabinet has been damaged.

If you need additional safety information concerning the Printer or supplied materials, you may call the following toll-free number:

1-800-828-6571.

(continued)

XES Synergix 8825/8830 Printer Operator Manual

3

Image 7
Contents XES Synergix 8825/8830 Printer Operator Manual Class a EME Compliance in CanadaTrademark Acknowledgments Introduction For Service on Your PrinterTable of Contents Safety Notes Safety Notes Ground Fault Protection Printer Overview Cutter Drawer Printer On/Off SwitchController On/Off Switch Ground Fault ProtectorToner Waste Container Front View front door openPrevious Button Numeric Keypad Cancel/Clear ButtonGraphic Display Message Display Language Button Media ButtonSwitching On and Off Power ON/OFFPrinter is Warming UP Rest Mode Fuser is OFF Press Enter to Warm UP Printer Power Saver, Rest ModesLoading the Rolls of Media Media InformationMedia Information Media Information Media Information Media View Menu Enter to Change Media in Roll 1 is 36.0 Inch BondSelect Media Width 36.0 Inch Select Media Type Bond Manual Bypass Feed Printer Menu OFF-LINE MenusPrinter Menu Entry Audible IndicatorsPrinter Menu Alarm = on Printer Menu Audible IndicatorsKeypress = on Timers Printer Menu TimersPower Saver to Rest = xxx Minutes Printer Adjustments Printer Menu Printer AdjustmentsEnter NEW Value 0 Finisher Config Type = Printer Menu Finisher SettingsFinisher Settings Finisher Config Type = NoneDiagnostics Printer Menu DiagnosticsTest Plot Billing Meters Printer Menu Billing MetersStatus Codes Problem SolvingStatus Explanation Code Media Jams Error Messages Checking for Loss of Power Vellum Problem What to DoPrint Quality Bond PaperReplacing the Toner Cartridge CareCare Remove the red cover tape Replacing the Toner Waste Bottle Required Tasks Calling for ServiceSupplies Order List Ordering SuppliesXES Synergix 8825/8830 Printer Printer DimensionsEnvironmental Requirements Electrical SpecificationsPower Consumption Heat DissipationPrints per Minute Bond Media Size Portrait Landscape XES Synergix 8825/8830 Printer Operator Manual USA USA