Xerox XES 8855 manual Cleaning the Upper Corotron

Page 39

CARE

Cleaning the Upper Corotron

Periodic cleaning of the corotron will reduce print quality problems caused by accumulation of toner inside the printer.

CAUTION

Use care when removing and replacing the corotron to avoid scratching the photosensitive drum inside the printer. Do not force the corotron in or out of

the printer.

1.Switch off the power to the printer.

2.Open the right side cover.

3.Locate instruction label (1) and follow the instructions to remove and replace the upper corotron: (1).

5.Lay the corotron on a flat surface to expose the corotron wires for cleaning.

6.Clean the corotron wires using a lint-free cloth dampened with water.

7.Rub the wires gently from end to end until most of the toner is removed.

8.Turn the corotron over and clean the wire(s) on the other side.

9.Allow the corotron to dry before replacing.

33

Image 39
Contents XES 8855 Printer User Guide EMC Notices USA Trademark Acknowledgments Safety Notes Safety notes Table of Contents Safety Notes Safety Notes Ground Fault Protection Front View Printer OverviewRear View Right Side View Page Loading the Media Rolls 1, 2 Media InformationRoll 3 only Loading the Media Roll Media Information Making a Test Print Dehumidifier Manual Bypass Feed Page Status Indicators Problem SolvingCodeCause/What to Do Error CodesProblem Solving Top Drawer is not closed. Open and close Media Jam J-01, J-02 Clearing the Media PathMedia Jam J-03 Media Jam J-04 Media Jam J-05 Media Jam J-11 Media Jams J-12, J-13 Media Jam J-14 Page Replacing the Toner Cartridge CareCare Replacing the Toner Waste Container Replacing the Oil Pads Cleaning the Upper Corotron Cleaning the Lower Corotron XES Product SpecificationsPower Consumption Conformité EEM au Canada FCC Compliance in the USA EME Compliance in Canada701P9241412/00